These snow chains form an important part of your car’s winter equipment for safe driving on snow and ice. Please observe the following instructions carefully.
Chains can be mounted on all tyres with indicated dimensions, except for oversize tyres, for which you could have some difficulties in mounting. Chains cannot
be mounted on those tyres and vehicles which are not designed to carry chains. It is advisable to make a test mounting before use in a convenient place.
Snow chains must be checked for signs of wear before and preferably also after using them. If there is any obvious damage or links are less than 50% of their
original thickness then the chains must be replaced.
Chains are designed to fit a range of tyres with different dimensions. In order to get the best fit on your particular tyres, we recommend that, after travelling for
half a kilometre or so, you should stop the vehicle and re-tighten the chains. This is important both for your safety and to reduce the risk of vehicle damage!
The use of chains affects the way your car handles. Please drive with extra care on snow-covered roads and NEVER exceed 50 km/h!
If roads are not uniformly covered by snow, again the maximum speed is 50 km/h. If roads are completely free from snow and ice, you should definitely remove
the chains as soon as possible. Until you find a safe place to do this you should reduce your speed further for safety reasons and to avoid excessive chain
wear.
The life expectancy of the chains depends on speed and driving habits. Especially on roads free from snow and ice, you should avoid spinning the tyres when
moving off.
Chains are electro-galvanized. They may corrode during usage, especially due to salt on the roads. It is important that chains are washed in warm water as
soon as possible after use in order to eliminate the deposits of salt and to prevent rust. They should then be thoroughly dried with a towel and protected with
a little grease before returning to the storage bag/container.
We cannot accept responsibility for wear and tear of chains, or for defects caused by incorrect use or by incorrect mounting.
In case of any apparent defective performance, remove the chains immediately. If a chain link breaks, it is usually possible to replace it using a repair link. For
this you need a pair of pliers. You are advised to carry a pair with your chains.
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Weissenfels NEWTECH 9 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Weissenfels NEWTECH 9 in the language / languages: English as an attachment in your email.
The manual is 0,76 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
The manual is sent by email. Check your email
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
