805497

Watts Wireless outdoor sensor Manual

1
Zoom out
Zoom in
Previous page
1/2
Next page
“ RF init ”
Wireless outside temperature probe
1. INSTRUCTION
- The probe must be placed on the wall with the enclosed screws, or otherwise if the support is
not appropriated.
- It must be vertically installed as indicated on the installation scheme (holes allowing air
circulation down).
Once fixed on the wall, don’t forget to put the rubber caps provided to ensure the tightness of
the box against dripping water.
- the probe must be preferably placed on a north or north/west wall sheltered for weather and
away from parasites of heat sources such suction, exhaust air of the building, …
2. RF INITIALISATION & BATTERY REPLACEMENT
To initialize your RF outside probe with your control system, make sure that it is properly
configured to work with an RF probe.
- Then, place your control system in « RF init » mode (see the instruction manual of the control
system)
- Remove the protector film of the battery
- Then switch on the RF probe (pointing up) : the status led blinks green
- Check on your control system the good reception of the signal
- If the configuration unfolds as it should, close the box of the RF probe
- If the configuration doesn’t unfold as it should, try to place the antenna of the control system
as close as possible of the RF probe.
3. TECHNICAL CARACTERISTICS
Operating temperature -10°C to 55°C
Power supply
Operating life
2 AAA (LR03)
~ 5 years
Radio Frequency
433.92 MHz <10mW.
Range of approximately 180m in open space.
Range of approximately 30m in residential environment
Homologations EN 300220-1, -2 / EN 301489-1, -3
R&TTE
Electrical protection IP 45
Status LED
Blinking green (flash 10sec)
RF initialization
4. Battery replacement
- Switch off your RF probe
- Take off the used batteries (Do not throw your batteries in the trash, recycle as it should be)
- Put the new batteries (always replace the 2 batteries in the same time)
- Switch ON your probe (pointing up), the led status blinks green.
- Close the box
ON
52mm
80mm
80mm
OFF
ON
OFF
ON
OFF
ON
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Watts Wireless outdoor sensor at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Watts Wireless outdoor sensor in the language / languages: English, French as an attachment in your email.

The manual is 0.54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info