718912
15
Zoom out
Zoom in
Previous page
1/16
Next page
- 13 -
APPENDIX: TROUBLESHOOTING
In general the Wartmann vacuum device performs adequately. Should however a malfunction occur,
then please first try the troubleshooting recommendations mentioned below.
POSSIBLE CAUSE
SOLUTION
The power cord is damaged, the
plug is not in the socket or there is
no voltage on the socket.
First check if the power cord is
undamaged and then insert the
plug into a socket which you know
has power.
You press on the “vacuum seal or
the “vacuum only” button while
there was already a vacuum.
Unlock the lid. This will remove
the vacuum in the vacuum
chamber.
The top of the vacuum bag is not
entirely into the vacuum chamber
(over the sealing strip).
Place the opening of the vacuum
bag entirely in the vacuum
chamber.
There are wrinkles in the vacuum
bag in the part that is on the
sealing strip.
Check the top side for wrinkles,
and, if necessary cut off the top
edge of the vacuum bag.
You have made a vacuum bag of a
vacuum roll and the first sealing is
not correct.
Check the first sealing for
damage. Cut off the damaged
sealing and make a new sealing.
Sharp objects could puncture the
vacuum bag.
Cover any sharp edges using a
paper towel and use a new
vacuum bag.
Certain vegetables and fruit that
were not properly blanched or
were frozen prior to packaging,
may cause decomposition gases.
Open the packaging and throw
away the foods in case they are
spoiled. If the foods are not
spoiled, they must be eaten
straight away.
The sealing strip of the vacuum
bag is wet, dirty or dusty.
Remove the plug and clean the
sealing strip. Use only clean, dry
vacuum bags.
The bag is not placed over the
sealing wire.
Check that the bag is properly
placed over the seal wire.
The open end of the bag is inside
the vacuum chamber.
Place the open end of the bag just
over the sealing wire. For sealing
without vacuum the open end of
the bag should not be inside the
vacuum chamber.
There is a technical failure
malfunction.
Remove the plug from the socket,
wait 10 seconds and reconnect
the vacuum device.
Send the vacuum device in for
repair.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Wartmann WM-1507 SL at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Wartmann WM-1507 SL in the language / languages: English as an attachment in your email.

The manual is 0,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info