649019

Wagner ProSpray 3.21 Manual

4
Zoom out
Zoom in
Previous page
1/32
Next page
4 ProSpray 3.21
GB
Safety Regulations
1. Safety regulations for Airless
spraying
This manual contains information that must be read and understood
before using the equipment. When you come to an area that has one of
the following symbols, pay particular attention and make certain to heed
the safeguard.
This symbol indicates a potential hazard that may cause
serious injury or loss of life. Important safety information
will follow.
Attention
This symbol indicates a potential hazard to you or to the
equipment. Important information that tells how to
prevent damage to the equipment or how to avoid
causes of minor injuries will follow.
A hazard symbol such as this one refers to a specific,
task-related risk. Be sure to heed the safeguard.
i
Notes give important information which should be given
special attention.
HAZARD: INJECTION INJURY
A high pressure stream produced by this equipment
can pierce the skin and underlying tissues, leading to
serious injury and possible amputation.
DO NOT TREAT AN INJECTION INJURY AS A
SIMPLE CUT! Injection can lead to amputation. See a
physician immediately.
The maximum operating range of the unit is 221 bar
(22.1 MPa, 3200 PSI) uid pressure.
PREVENTION:
• NEVERaimthegunatanypartofthebody.
• NEVERallowanypartofthebodytotouchtheuid
stream.DONOTallowbodytotouchaleakintheuid
hose.
• NEVERputyourhandinfrontofthegun.Gloveswill
not provide protection against an injection injury.
• ALWAYSlocktheguntrigger,shuttheuidpumpoff
and release all pressure before servicing, cleaning
the tip guard, changing tips, or leaving unattended.
Pressure will not be released by turning off the engine.
ThePRIME/SPRAYvalveorpressurebleedvalve
must be turned to their appropriate positions to relieve
system pressure.
• ALWAYSkeeptipguardinplacewhilespraying.The
tip guard provides some protection but is mainly a
warning device.
• NEVERuseaspraygunwithoutaworkingtriggerlock
and trigger guard in place.
• ALWAYSremovethespraytipbeforeushingor
cleaning the system.
• Thepainthosecandevelopleaksfromwear,kinking
and abuse. A leak can inject material into the skin.
Inspect the hose before each use.
• Allaccessoriesmustberatedatorabovethe
maximum operating pressure range of the sprayer.
This includes spray tips, guns, extensions, and hose.
NOTE TO PHYSICIAN:
Injection into the skin is a traumatic injury. It is
important to treat the injury as soon as possible. DO
NOT delay treatment to research toxicity. Toxicity is a
concern with some coatings injected directly into the
blood stream. Consultation with a plastic surgeon or
reconstructive hand surgeon may be advisable.
HAZARD: EXPLOSION OR FIRE
Solvent and paint fumes can explode or ignite. Severe
injury and/or property damage can occur.
PREVENTION:
• Provideextensiveexhaustandfreshairintroduction
to keep the air within the spray area free from
accumulationofammablevapors.
• Avoidallignitionsourcessuchasstaticelectricity
sparks,electricalappliances,ames,pilotlights,hot
objects, and sparks from connecting and disconnecting
power cords or working light switches.
• Plasticcancausestaticsparks.Neverhangplastic
to enclose spray area. Do not use plastic drop cloths
whensprayingammablematerials.
• Alwaysushunitintoseparatemetalcontainer,atlow
pump pressure, with spray tip removed. Hold gun
rmlyagainstsideofcontainertogroundcontainerand
prevent static sparks.
• Donotsmokeinsprayarea.
• Fireextinguishermustbepresentandingoodworking
order.
• Placesprayeratleast6.1m(20feet)fromthespray
objectinawellventilatedarea(addmorehoseif
necessary).Flammablevaporsareoftenheavierthan
air. Floor area must be extremely well ventilated. The
pump contains arcing parts that emit sparks and can
ignite vapors.
• Theequipmentandobjectsinandaroundthespray
area must be properly grounded to prevent static
sparks.
• Useonlyconductiveorearthedhighpressureuid
hose. Gun must be earthed through hose connections.
• Powercordmustbeconnectedtoagroundedcircuit
(electricunitsonly).
• Theunitmustbeconnectedtoanearthedobject.Use
the green earthing wire to connect the unit to a water
pipe, steel beam, or other electrically earthed surface.
• Followmaterialandsolventmanufacturer’swarnings
andinstructions.Befamiliarwiththecoatingmaterial’s
MSDS sheet and technical information to ensure safe
use.
• Donotusematerialswithaashpointbelow21°C
(70°F).Flashpointisthetemperatureatwhichauid
can produce enough vapors to ignite.
• Uselowestpossiblepressuretoushequipment.
PE
0 bar
… 4 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Wagner ProSpray 3.21 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Wagner ProSpray 3.21 in the language / languages: English as an attachment in your email.

The manual is 3,03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info