540479

Vortex Viper PST Manual

9
Zoom out
Zoom in
Previous page
1/11
Next page
Align the elevation turret cap.
Align the windage turret cap.
16 17
Once the CRS shims are installed, the elevation dial will
stop turning shortly past the original zero point when being
returned (turning clockwise direction) from a temporary
elevation adjustment.
Turn the elevation knob a partial turn in a counter-clockwise
direction until the Radius Bar is correctly aligned with scope
axis and zero marks match. This setting will match the
original zero point.
If re-zeroing at a future time, be sure to remove all CRS
shims before sight-in.
1. Loosen the three retaining screws on windage turret cap.
2. Carefully rotate the cap until the “0” mark on the cap
matches up with the “0” reference line on the turret post. Be
sure that the cap is freely turning and that you don’t rotate the
actual turret mechanism.
3. Re-tighten the windage knob retaining screws, but do not
overtighten. Use of thumb and forefinger on the short end
of the hex wrench will provide
sufficient force.
Once the windage and elevation
knobs are correctly indexed to the
zero mark, temporary corrections
can be safely dialed into the
scope without worry of losing the
original zero.
Indexing the Windage Knob
Correct alignment for
zero point.
Using the CRS Zero Stop
Point at which the
knob stops turning.
1. After filling the center gap on the post with shims, replace the
elevation cap.
2. Align the turret cap so the “0” mark on the cap matches up
with the “0” reference line on the turret post. Again, be sure not
to rotate the actual turret mechanism in the process.
3. Re-tighten the retaining
screws, but do not overtighten.
Use of thumb and forefinger on
the short end of the hex wrench
will provide sufficient force.
… 9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vortex Viper PST at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vortex Viper PST in the language / languages: English as an attachment in your email.

The manual is 0,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info