703297
4
Zoom out
Zoom in
Previous page
1/8
Next page
EN Instructions
Customer Service / Importer:
DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin, Germany • +49 38851 314650 *)
*) Calls to German landlines are subject to charges. The cost varies depending on the service provider.
All rights reserved.
Z 01773 M DS V1 0618
Inserting / Changing the Battery
Before inserting the battery, check whether the con-
tacts in the battery compartment (3) and on the battery
are clean, and clean them if necessary.
1. For this purpose, unscrew the lower section of the
housing in a clockwise direction and remove it from
the basic device (5).
2. If necessary remove any used battery and insert 1 x
1.5 V battery, AA type into the battery compartment
with the negative (minus) pole to the front.
3. Attach the lower section of the housing to the basic
device once more and turn it in an anti-clockwise
direction to x it into position.
Replace the battery when the power of the device starts
to become weaker.
Attaching / Removing Attachments
To attach the attachment, place it on the basic
device (5) and turn it clockwise to x it into position.
To remove the attachment again, turn it in an anti-
clockwise direction.
Application
PLEASE NOTE!
Do not use the device for longer than 60 seconds on
each treatment so that you do not irritate the skin on
the face too much.
When cleansing the face with the device, avoid the
area around the eyes.
PLEASE NOTE: Treatment with the device can result in
slight reddening of the skin immediately after the treat-
ment. A warm or tingling sensation may occur during
the cleansing. Both the reddening and the sensation
will usually disappear after a few minutes. If the skin
should feel dry and aky and stay red for a prolonged
period of time, you may have pressed the device too
rmly against your face or persisted on one spot for
too long. Try to exert less pressure and treat the cor-
responding spot for less time when you next use the de-
vice. If the symptoms persist over a prolonged period,
consult a doctor.
Cleansing the face
1. Moisten the face.
2. Attach the brush attachment (6) to the basic de-
vice (5).
3. Rinse the brush attachment under running water!
4. Apply a cleansing product to the face or the brush
attachment as required.
5. Press the On / Off switch (4) to switch on the device:
Press 1 x: light vibration
Press 2 x: strong vibration
Press 3 x: Off
6. Move the brush attachment in a circular motion over
the face and massage the cleansing product into the
skin. We recommend: 20 seconds for the forehead,
20 seconds for the nose / chin and 10 seconds for
each cheek.
7. Press the On / Off switch until the device switches off.
8. Rinse the face with fresh water if a cleansing prod-
uct has been used.
9. Remove the brush attachment from the basic device.
PLEASE NOTE: After some time the brush attachment
will become worn. Because worn bristles can irritate
the skin, we recommend regular replacement of the
brush attachment.
Applying cream and massaging
1. Attach the silicone attachment (1) to the basic de-
vice (5).
2. Apply a cleansing product to the face or the silicone
attachment as required.
3. Press the On / Off switch (4) to switch on the device:
Press 1 x: light vibration
Press 2 x: strong vibration
Press 3 x: Off
4. Move the silicone attachment in a circular motion
over the face and massage the cleansing product
into the skin.
5. Press the On / Off switch until the device switches off.
Cleaning and Storage
PLEASE NOTE!
Do not clean the attachments in the dishwasher.
Do not use any corrosive or abrasive cleaning
agents to clean the device. These can damage the
surface.
Only ever dry the attachments in the air, and never
use a tumble dryer or a hair dryer to do this!
1. Remove the attachment used from the basic de-
vice (5).
2. Clean the attachment under hot running water and
allow it to dry in the air.
3. When necessary clean the basic device with a
moist cloth.
4. Store the device and accessories in a dry place
which is not accessible to children and animals.
Technical Data
Article number: 01773
Model number: RH-0156
Power supply: 1.5 V DC (1 x 1.5 V battery, Type AA)
Disposal
Dispose of the packaging material in an environ-
mentally friendly manner so that it can be recycled.
Dispose of the device in an environmentally
friendly manner at a recycling centre for used
electrical and electronic devices. It should not be
disposed of in the regular domestic waste.
The battery should be removed prior to disposal
of the device and disposed of separately from the
device at a suitable collection point.
Article number: 01773
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vitalmaxx RH-0156 - Z01773 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vitalmaxx RH-0156 - Z01773 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info