484572
1
Zoom out
Zoom in
Previous page
1/3
Next page
Courtesy of:
Vibiemme Double Boiler Supplemental Instructions
Turning on and priming:
1. If reservoir model, rinse and fill the reservoir. If plumbed in version, connect and open
water supply (water softener and water pressure regulators requirements are covered
separately)
2. Plug the machine in and turn the switch to position “I” (one). The Power light on far right
will come on. NOTE: Setting the rotary switch to position “I” will activate all the
functions of the machine such as the autofill circuit, power to the PID, power to the
pump, solenoid valve, microswitch for the lever and power the brew boiler heating
element (but not the steam boiler heating element). The machine should arrive with the
PID turned off and it is very important for the PID to remain OFF until both of the boilers
are primed. When the PID is OFF, there is no power supplied to the brew boiler heating
element.
Upon turning the switch to position “I” the display will turn on and show the software
version (ex. 1.00). Then after few seconds, the word OFF will appear. If OFF is not
displayed and you see a temperature reading instead, immediately push and hold the right
side button on the PID to turn it off.
3. Within a few seconds the autofill should turn on (you will hear the pump) and the steam
boiler will fill until the proper level is reached. For reservoir models keep an eye on the
water reservoir and make sure that the water level is going down.
4. It is possible that the steam valve and hot water spout have been opened for shipping,
especially in the winter months to avoid freezing issues. If they are open, now is a good
time to close them. However, if they arrived closed, now is a good time to open them to
release negative/cold air that may have accumulated in the boiler.
5. After the steam boiler’s autofill is completed, engage the grouphead lever (pump will
start again). Allow a few ounces of water to flow out the group, and then turn the lever
down (off).
Now both of the boilers of your machine are primed.
6. At this point, turn the PID ON by pushing and holding the right button. The word OFF
will disappear and the PID will start reading brew boiler temperature. For the US market,
the default temperature reading is in degrees F. If you prefer degrees C it can easily be
changed with the instructions we will cover further along.
7. The steam boiler can now be turned on by turning the switch to position II (the left light
will come on indicating that power is passing through the pressurestat and reaching the
heating element).
v.7/09
1
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vibiemme Vibiemme Double Domobar version 3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vibiemme Vibiemme Double Domobar version 3 in the language / languages: English as an attachment in your email.

The manual is 0,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Vibiemme Vibiemme Double Domobar version 3

Vibiemme Vibiemme Double Domobar version 3 User Manual - English - 74 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info