Troubleshooting
Problem
Cleaner won’t run
Vacuum won’t pick up/
loss of suction
Dust escaping from the
Vacuum
Cleaner won’t dispense
solution
Possible Cause
• Power cord not firmly pushed into
a mains socket.
• Blown fuse or tripped circuit breaker.
• Dirty water tank is not installed
correctly.
• Dirty water tank is full.
• Floating brushbar is worn.
• Nozzle/dirt passage is clogged.
• Dirty water tank is full.
• Dirty water tank is not installed
properly.
• Solution reservoir not installed
correctly.
• Solution reservoir not installed
correctly.
• Solution tank empty.
Possible solution
• Plug cord in firmly.
• Check fuse/breaker. Replace fuse or
reset breaker.
• Refer to page 9 for fitting information.
• See ‘Emptying the dirty water tank’.
• Replace the brushbar.
• Remove obstruction.
• Empty dirty water tank.
• See ‘Emptying the dirty water tank’
• See ‘How to operate your cleaner’.
• See ‘How to operate your cleaner’.
• Fill tank see page 4 and 5.
12
• Do not leave the appliance when plugged in. Unplug it from socket when not in use.
• To prevent electric shock do not use outdoors
• Not to be used as a toy. Close supervision is necessary when used by or near children or the infirm.
• Use only as described in this user guide.
• Do not use with a damaged cord or plug.
• Do not pull or carry by the cord, use the cord as a handle, allow the cord to come into contact with hot or sharp
surfaces or close a door on the cord.
• Do not unplug by pulling on the cord.
• Do not handle the plug or appliance with wet hands.
• Do not put any objects into openings or operate with openings blocked, keep them free of anything that may reduce
airflow.
• Keep hair, loose clothing, fingers, and all parts of the body away from openings and moving parts.
• Do not vacuum any glowing, burning or smoking particles.
• Do not use without the solution reservoir and dirty water tank in place.
• Turn off all controls before unplugging.
• Do not use to pick up flammable or combustible liquids such as petrol, or use in areas where they may be present.
• Keep the carpet washer on the floor.
• Do not use an extension cord with this carpet washer.
• Do not attempt to remove blockages with sharp objects as they may cause damage.
• Store the carpet washer indoors. Put the carpet washer away after use to prevent tripping accidents.
• Using improper voltage may result in damage to the motor and possible injury to the user. The correct
voltage is listed on the ratings plate.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid hazard.
• This carpet washer is intended for household use only.
• This is not a dry vacuum cleaner, carpets should be thoroughly vacuumed prior to washing with the Rapide
Classic.
For further information in the UK, call the VAX HELPLINE : 0870 606 1248
13
Safety
