POWEG9012 EN
Copyright © 2019 VARO P a g e | 7 www.varo.com
▪ Use the blower as follows when working on slopes:
▪ Keep the air outlet unobstructed and clean at all times.
▪ Never direct the suction/blown air opening toward persons or animals.
7 ASSEMBLY
Your new blow/vac requires very little assembly work before it is ready for use.
Warning: if any part is missing or damaged, do not plug in the machine
until you have replaced the missing or damaged part.
7.1 Assembling the tubes (Fig. 1, 2)
1. Slide the top tube section into the motor housing, then tighten the screws on both
sides and make sure the tube is firmly fixed to the motor housing.
2. Insert the bottom section tube into the top section tube and push them until they
are connected firmly together. Finally tighten the screws on both sides.
7.2 Shoulder belt
Attach the shoulder belt to the foreseen hook on the handle. To adjust the shoulder belt
to the required length, simply slide the adjustable strap buckle forward or backwards.
7.3 Collection bag (Fig. 3)
Before fitting the collection bag ensure that the blow - vacuum function selector lever
operates smoothly and that it is not obstructed by debris from the previous use.
Secure the hook of the collection bag to the tube and then install the entrance of debris
of the collection bag in the foreseen opening.
8 OPERATION
8.1 Steps prior to operation
Only operate the device after completely assembling it. Prior to each use, check the
power cord for signs of damage. Under no circumstances should the power cord be
used if it shows any signs of damage.
Ensure that the blow/vac is only connected to conventional sockets with a 230 V
alternating current supply.
8.2 Switching ON/OFF (Fig. 4)
Press the On/Off switch to start machine.
To stop the machine simply let go of the On / Off switch.
8.3 Use/Operation
▪ The easiest way to use the blow/vac is to place the shoulder belt in a comfortable
position over your shoulder and hold the rear handle at hip height so that the majority
of the tool’s weight rests on the rollers.
▪ When using the blow/vac to pick up leaves it is best to move the tool on its rollers.
This ensures that the blow/vac is at the perfect height above the ground. The
blow/vac is designed only to pick up leaves. To avoid damage to the tool that is not
covered by the warranty, do not use it to pick up branches, stones or other hard
materials.
