622518
1
Zoom out
Zoom in
Previous page
1/2
Next page
MOTKC48EL - MOTSA07EL EN
Copyright © 2012 VARO NV P a g e | 1 www.varo.com
OPERATING INSTRUCTIONS
CAUTION: Do not keep the keys in the safe.
1 OPENING THE SAFE FOR THE FIRST TIME
To open the safe for the first time, remove the small central cover Z (see diagram 2) between
knob and keypad, insert the key into the lock and turn it counter-clockwise, at the same time,
turn the doorknob clockwise and open the door.
2 INSTALLING THE BATTERIES
The safe requires 4x size AA(1.5V) batteries.
The batteries compartment Y (see diagram 1) is located on the back of the door. Remove the
battery cover and install the batteries into the compartment. Ensure the batteries are fitted with
the correct corresponding polarity.
Once the batteries are installed, close the battery compartment.
3 PROGRAMMING THE CODE
A. Remove the battery cover and press the red button “Xinside the battery compartment (see
diagram 1), release it and you will hear two beeps.
B. Now press from 3 to 8 numbers that you wish to use as a combination, and confirm by
pressing the letter “B” within 15 seconds. Or you have to do from the beginning.
C. Write down your new combination immediately and check whether your new combination
has been programmed or not on conditions of the safe door open.
4 USING YOUR SAFE
To open the safe, enter your personal code and confirm by pressing the letter “A”. You will
hear a beep and the green light will be on, then open the door using the knob within 5 seconds.
If you or an intruder uses the incorrect group of numbers, it will not open. If the incorrect
combination is used 3 times consecutively, you must wait for 20 seconds before reattempting.
If again the incorrect combination is selected 3 times, you must wait approximately 5 minutes
before reattempting access.
5 BATTERY REPLACEMENT WARNING
If the batteries are low, the red light (in the left) will warn you immediately.
To test the batteries, just input your personal numbers to open the door. If the batteries are
low, the red light will be on. If nothing happens, it means that batteries are in order.
6 REPLACING THE BATTERIES
The safe requires 4× size “AA” (1.5V/R06) batteries. Open the safe, push the battery cover
plate “Y”(see diagram 1) on the back of the door and replace the 4 PCS old batteries. You
must reprogram the code, using the above third step.
Use of alkaline batteries is recommended.
7 OVERRIDE INSTRUCTION TO OPEN THE SAFE
For your convenience, we have engineered a manual override system for your safe. If you
forget or misplace your combination, remove the small central plate “Z “(see diagram 2) on the
front panel, insert the key into the keyhole and turn it in a counter-clockwise direction, then
turn the knob in a clockwise direction towards the right. This will manually open your safe at
any time.
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Varo MOTSA07EL at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Varo MOTSA07EL in the language / languages: English as an attachment in your email.

The manual is 0,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Varo MOTSA07EL

Varo MOTSA07EL User Manual - German - 2 pages

Varo MOTSA07EL User Manual - Dutch - 2 pages

Varo MOTSA07EL User Manual - French - 2 pages

Varo MOTSA07EL User Manual - Spanish - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info