469481
59
Zoom out
Zoom in
Previous page
1/64
Next page
17Gebruiksaanwijzing atmoTEC pro/atmoTEC plus en turboTEC pro/turboTEC plus 0020029202_01
4.7.2 Storingen bij de ontsteking
bar
2
1
Afb. 4.15 Reset
(hier afgebeeld: atmoTEC/turboTEC plus)
Als na drie ontstekingspogingen geen ontsteking van de
brander volgt, schakelt het toestel niet in en schakelt
naar storing. Dit wordt aangegeven door weergave van
de storingscodes "F. 28 " of "F. 2 9 " op het display.
atmoTEC/turboTEC plus:
Bovendien wordt op het display een vlamsymbool met
kruis (1) weergegeven.
atmoTEC/turboTEC pro:
Bovendien brandt de rode signaallamp.
Een nieuwe automatische ontsteking vindt pas na een
handmatige reset plaats.
Druk voor de reset op de resetknop (2) en houd deze
ca. een seconde ingedrukt.
a
Attentie!
Gevaar voor beschadiging door ondeskundige
veranderingen!
Als uw gaswandketel na de derde resetpoging
nog altijd niet in bedrijf gaat, moet u een erkend
installateur voor de controle om advies vragen.
4.7.3 Storingen in het rookgastraject
Alle atmoTEC/turboTEC-toestellen zijn uitgerust met een
controlevoorziening van het rookgastraject. Bij niet cor-
recte werking van het rookgastraject wordt het toestel
uitgeschakeld.
- Op het display van de toestellen atmoTEC/turboTEC
plus verschijnen dan de symbolen
en .
- Bij de atmoTEC/turboTEC pro-toestellen brandt de
rode LED permanent.
- Bij alle toestellen verschijnt een storingsmelding:
atmoTEC: F. 3 6
turboTEC: F. 3 3
a
Attentie!
Gevaar voor beschadiging door ondeskundige
veranderingen!
Bij deze foutmelding moet u een erkend instal-
lateur voor de controle om advies vragen.
4.7.4 Toestel/CV-installatie vullen
bar
2
1
Afb. 4.16 Waterdruk van de CV-installatie controleren
(hier afgebeeld: atmoTEC/turboTEC plus)
Controleer vóór in de inbedrijfstelling de waterdruk
van de installatie op het display (1) of op de manome-
ter (2). Voor een storingsvrij bedrijf van de CV-installa-
tie dient bij koude installatie op het display een water-
druk tussen 1,0 en 2,0 bar getoond te worden (op de
manometer bevindt de wijzer zich dan in het lichtgrijze
gebied). Bedraagt de waterdruk minder dan 0,8 bar (de
wijzer van de manometer bevindt zich dan in het don-
kergrijze gebied), moet vóór de inbedrijfstelling water
bijgevuld worden.
h
Aanwijzing!
De aanduiding van de systeemdruk op het dis-
play functioneert enkel wanneer het toestel op
het elektriciteitsnet aangesloten en ingescha-
keld is!
Aanwijzing!
(alleen voor atmoTEC/turboTEC met aangeslo-
ten warmwaterboiler)!
Bij de levering van het toestel is een vulvoorzie-
ning inbegrepen. Deze wordt door uw installa-
teur zelf geïnstalleerd.
Als de CV-installatie zich over meerdere etages uitstrekt,
kan een hogere waterdruk van de installatie nodig zijn.
Vraag hiervoor uw installateur.
Bediening 4
BENL
59


Need help? Post your question in this forum.

Forumrules
1

Forum

vaillant-turbotec-pro

Reset search

  • Hi - I have just arrived back to Spain after 7 months - and when I turned on the GAS I couldn't get any warm water - the GAS in the kitchen was OK. After few seceonds it shows F75 and no warm water.
    What to do? I have a turbo TEC Pro. Submitted on 11-4-2022 at 17:46

    Reply Report abuse
  • Good morning
    Boiler vaillant turbotec
    When i turn on the boiler the pressure is rising to the maximum ( end of red) over 3.5 bar
    How can i fix this problem?
    Thank you Submitted on 18-10-2020 at 11:32

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vaillant turboTEC pro at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vaillant turboTEC pro in the language / languages: German, Dutch, French as an attachment in your email.

The manual is 6,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Vaillant turboTEC pro

Vaillant turboTEC pro Manual - Dutch - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info