581336
7
Zoom out
Zoom in
Previous page
1/8
Next page
11
12
16
17
- AA SIZE +
- AA SIZE +
System Type
Gas - Standing Pilot
Gas - Electronic Ignition
Gas - Fire Boiler
Gas - Millivolt System
Oil - Fire Boilers
Oil - Fire Furnace
Electric Furnace
Electric Air Conditioner
Baseboard Electric Heater (120/240V)
Heat Pump/Multi- Stage equipment
Compatibility
Generally, equipment with low voltage control is compatible with the THM301M thermostat. For
details on compatibility of your particular equipment, please call our technical assistance line.
continuously to improve air ventilation. To return to automatic control, set the switch to the AUTO
position.
Heat/Cool Control Switch
! If this switch is on the OFF position, both the heating and cooling systems are turned off, and all
programs and settings will be disabled.
! Slide the switch to HEAT or COOL to control the heating or air-conditioning system.
! The symbols HEAT or COOL on the display will be flashing when heating or cooling is activated.
Pre-Comfort Recovery
This thermostat is equipped with a ‘Pre-Comfort Recovery’ system that will activate the heating or
cooling in advance of the actual set program time so that the room will be at the desired temperature
at the start of the comfort program time.
It is normal for the system to be activated earlier (up to ½ hour for heating and one hour for cooling)
than the actual set program time.
12/24 Hour Display Format
Press both AHEAD and BACK keys together at the same time to change the time display from 12
hour format to 24 hour format (e.g. 8:00pm / 20:00) and vice versa.
Changing Batteries
When all digits on the LCD display flashes, it indicates that the batteries are running low and have to
be replaced. However, it is recommended for the batteries to be replaced every year even if display is
not flashing yet. To replace batteries:
! Set the thermostat system switch to the OFF position and have the new batteries on-hand.
! Open the thermostat by pressing on the 2 tabs on the top.
! Remove the old batteries and install new ones quickly.
! Close the thermostat to its original position.
If new batteries are inserted within 20 seconds of removing the old ones, the existing time and
programs will not be cleared. Otherwise, the display will show 9:00a.m. and the thermostat will have
to be re-programmed.
Installation
The following tools may be required for installation:
See below to select a suitable place for the new thermostat installation. And refer to "Replacing Old
Thermostat" section to replace old thermostat.
Compatible with THM301M
Yes
Yes
Yes
Yes
Yes
Some models
Some models
No
No
Two AA size batteries (included)
Wire Stripper/Cutter
(If necessary, to strip the wires)
Level
(If necessary, to level the thermostat)
Masking Tape
(To wrap the exposed wires temporarily and labeling
the disconnected wires)
Hand Power Drill with a 3/16 inch bit
( If necessary, to drill holes on the wall )
Cross (Phillips) screwdriver
Yes
* Not compatible with any 120/240 volt circuit
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for UPM THM301M at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of UPM THM301M in the language / languages: English as an attachment in your email.

The manual is 1,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of UPM THM301M

UPM THM301M User Manual - French - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info