557352
10
Zoom out
Zoom in
Previous page
1/12
Next page
GB
18
The position of the BCJ-6910 chest belt can be adjusted both up and down. The
product is set in the upper position when it is shipped, as shown (Fig. 57). If the lower
position fits better, remove the end of the belt from the buckle, thread through the
lower hole of the belt holder, and set. If the belt still wraps around the shoulder part in
the same way as it did when in the upper position, it will deform the end of the
shoulder part. To avoid this, be sure to set by directly folding back with the belt holder
as shown (Fig. 58).
(Fig. 58)(Fig. 57)
Belt Holder
Buckle
CHEST BELT POSITION ADJUSTER (BCJ-6910)
The position of the BCJ-9300 and 7000 chest belt can be adjusted up and down. The
product is set in the upper position when it is shipped. (Fig. 59) In the lower position
fits better, slip the Slick Clip
®
of the chest belt from the loop of the shoulder belt as
shown (Fig. 60), thread through the lower loop and lock the Slick Clip
®
.
CHEST BELT POSITION ADJUSTER (BCJ-9300, 7000)
The BCJ-1800 weighs less than 2kg/4.4lbs and is designed for destination diving.
A buckle located behind the right side pocket can be used to roll and pack the BCJ-
1800 for travel.
ROLLUP BUCKLE (BCJ-1800)
(Fig. 59) (Fig. 60)
1919
SHOULDER ANGLE ADJUSTER (BCJ-9300, 6910)
The upper back section of the BCJ-9300 and 6910 is equipped with a shoulder angle
adjuster, for adjusting the opening of the shoulder belt (Fig. 55). When loading the
BCJ on to the tank, adjust the length of the adjuster belt to the desired position (Fig.
56).
* Does not need
to be adjusted for
every dive.
(Fig. 56)(Fig. 55)
DUMP VALVE
To operate the dump valve on the rear
of your right shoulder or lower back,
hold the knob and pull it sideways and
downwards, as shown in (Fig. 53, 54).
(Fig. 54)
(Fig. 53)
(Fig. 52)
(4) Finally, do up the chest buckle (Fig. 52), pulling the
end of the chest strap to one side to tighten it.
(3) Do up the waist buckle
(Fig. 50), pulling evenly on
both ends of the waist strap
to tighten it (Fig. 51).
(Fig. 51)(Fig. 50)
(Fig. 53)
BCJ(CE)002-021 GB 10.11.17 9:35 AM ページ 18
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Tusa Buoyancy Compensator Jacket at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Tusa Buoyancy Compensator Jacket in the language / languages: English as an attachment in your email.

The manual is 1,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info