808770

Turbotronic TT-SB58 Manual

2
Zoom out
Zoom in
Previous page
1/2
Next page
How to
Use the
Odor Filter
*if provided with
your model
General
Trouble-
shooting
Steps
The touchless sensor operation promotes a germ-free environment. The lid sensor uses
invisible and harmless, patented infrared technology for accurate and responsive lid open and
close operation. There are two buttons on the front of the lid, “OPEN” and “CLOSE”, to open
and close the lid manually, and an ON/OFF power switch on the back of the trash can lid. The
infrared sensor on the lid will automatically open the lid when your hand or object is within 6
inches/10 cm of the sensor. The lid will remain open if the sensor detects any object within its
radius and will automatically close in 4 seconds after the object is withdrawn.
1. When there is an object in the Sensor Zone, the LED Indicator Light will remain green and
the Lid will remain open until object is removed from the sensor zone.
indicate that the lid will close in 6 seconds.
red, the light will turn solid green again and the Lid will remain open.
About your
ibin
Trash Can
Some models of the Touchless Trash Can are equipped with an Odor
Filter Compartment that houses the odor-neutralizing Activated
Carbon Odor Filter. One (1) replaceable Odor Filter is pre-installed
inside the Odor Filter Compartment. Please follow these instructions
upside down.
2. Slide Odor Filter Compartment (Fig.1) to the right (Fig.2) to remove.
3. Remove Activated Carbon Odor Filter from the Compartment.
4. Remove new Odor Filter pouch from plastic bag (Do NOT cut open
the Odor Filter pouch).
5. Insert new Odor Filter pouch (Fig.3) into the Compartment.
6. Return the Odor Filter Compartment to Lid Cover (Fig.1) and slide
to the left (Fig.2) to lock the Odor Filter Compartment in position.
7. Replace Odor Filter every 3 months or when odor becomes too
strong.
the sensor area with a soft damp cloth and dry it immediately with a soft dry cloth.
Re-insert batteries or plug in AC adapter (DO NOT USE battery and AC adapter at the
same time).
2. Place trash can in an open area where nothing is blocking or within 10 inches of the
sensor eye. Make sure no sunlight or direct light shines on the sensor. Turn on the power
and try opening lid again.
3. If trash can is still not working correctly, remove the batteries or AC adapter. Let trash
can sit for at least 2 hours to reset. Try opening lid after reset.
Trouble-
shooting
Operating
Instructions
1. Remove Lid Unit from the trash can. Open battery compartment cover to insert 4 "D" size
batteries. Replace cover.
2. Insert one 13 gallon to 18 gallon trash bag through Trash Bag Retainer Ring and wrap the
top part of the bag over the Ring (STEP 1 in How To Use The Trash Bag Retainer Ring ). Put
the Ring onto the top edge of the can body (STEP 2).
3. Place Lid Unit onto the can body and make sure it is securely attached.
4. Turn on the power switch on the back of Lid Unit . A red Indicator Light will turn on for 3
5. Place hand or any object 6 inches above Infrared Sensor on the front of Lid Unit to open.
When there is an object in the Sensor Zone, the LED Indicator Light will remain green and
the Lid will remain open until object is removed from the Sensor Zone. Once item is
lid will close in 6 seconds. If an object is placed back into the Sensor Zone when the LED
open.
6. If you press the open button, Lid will open, and remain open for 5 minutes before closing
automatically – unless you press the close button. The trash can will then resume
operating in automatic mode.
How To
Use The
Trash Bag
Retainer
Ring
STEP
Place trash bag inside
trash can, then wrap the
top of the bag over Ring.
STEP
Secure Ring onto the
edge of the can body.
• Sensor Trash Can Lid
• Brushed Stainless Steel Can Body
Contents
of the Box
• Trash Bag Retainer Ring
• User Manual Fig. 3
Fig. 2
Fig. 1
Problem Solution
1. The trash can is brand new,
and only works occasionally
2. The lid stays open or lid opens
and closes continuously
3. Grinding noise when the lid
opens/closes
4. The lid does not open/close
5. I wave my hand over the sensor
eye, but the lid does not open
doesn’t work regularly, try a new set of batteries. Then follow the General
Troubleshooting Steps .
another direction, and follow the General Troubleshooting Steps .
This can be caused by broken gears or lid hinge.
• Check for damage on the hinges that connect to the lid
• Follow the General Troubleshooting Steps
If you are using Batteries:
• Turn power switch to “ON" position to see if the indication light is visible
If you are using AC Power Adapter:
• Unplug the adapter and insert new alkaline batteries to see if the lid works
on battery
• If the lid works with batteries, the AC adapter may be broken
It is not a motion sensor. Hold your hand or object steadily (do not wave your hand)
within 4-6 inches over sensor eye for it to detect and open.
Important: Do not use batteries
and the AC power adapter at the
same time. It can only be
powered by one source at a time.
www.zline-world.com
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Turbotronic TT-SB58 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Turbotronic TT-SB58 in the language / languages: English as an attachment in your email.

The manual is 0.44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info