489381

Truma Elektroboiler Manual

5
Zoom out
Zoom in
Previous page
1/24
Next page
5
Installation instructions
Installation and repair are only to be carried out by an
expert. Always read and follow the operating instructions
carefully prior to starting any work!
The year when the equipment was first taken into oper-
ation must be indicated with a check on the type plate.
Choice of location and installation
Select installation site (not in installation compartment behind
heater) such that the hot water pipes are as short as possible.
The boiler must be easily accessible at all times for service
work and be easy to remove and install.
Securely screw boiler to suitable surface (plywood panel,
laminated wood strips, or metal base) on floor of vehicle with
B 5.5 x 70 screws and washers (1). Always use the support
sleeves (2) that are preinstalled in the factory to reinforce the
insulating jacket.
Water connection
All pressure and submergible pumps up to 2.8 bar are used
for operating the boiler and all mixed combination sets with or
without an electrical switch.
Fig. A
When using immersion pumps, a non-return valve (3 – not
included in the scope of supply) must be fitted between the
pump and the first branch point (arrow points in direction of
flow).
Fig. B
When using pressure pumps with high switching hysteresis,
hot water may flow back through the cold water tap. To pre-
vent the backflow, we recommend that a non-return valve
(4 – not included in the scope of supply) be fitted between the
outlet to the hot water tap and the drain valve.
Hoses with an inner diameter of 10 mm that are pressure-re-
sistant (up to 3.5 bar) and hot water-resistant must be used for
connecting to the boiler and the safety/drain valve.
For non-flexible pipe routing (e.g. John Guest System) Truma
can supply the water connections (5 + 6), the safety/drain
valve (7) and a non-return valve (3 + 4) with a 12 mm diameter
inner connection as accessories.
If connecting to a central water supply (rural or city connec-
tion) or when using more powerful pumps, a pressure reducer
must be used which prevents pressures of greater than 2.8 bar
occurring in the boiler.
Route the water hoses so that they are as short and
free of kinks as possible. All hose connections must be
secured using hose clamps (also for cold water)! Pressures
of up to 3.5 bar can occur in the safety/drain valve (also in
submergible pumps) because of the heat of the water and the
resulting expansion.
We recommend the use of hose clips (part no. 40712-01)
to fasten the hoses to walls or the floor. If gas heating
has been installed, the water hoses and the hose clips can be
laid on the hot air pipes, which prevents frost.
In order to guarantee that the boiler is completely emp-
ty, the enclosed elbow with breather valve (5) must be
used for the hot water connection!
All water pipes should be routed in a descending man-
ner to the safety/drain valve! There shall be no claims
under guarantee for damage caused by frost!
Elektroboiler (Electric boiler)
17
14
5
6
16
8
7
24
1
2
20
3
9
17
14
5
6
16
8
7
9
4
24
20
1
2
A
B
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Truma Elektroboiler at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Truma Elektroboiler in the language / languages: English, German, Dutch, Danish, French, Italian, Spanish as an attachment in your email.

The manual is 1,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Truma Elektroboiler

Truma Elektroboiler User Manual - English, German, Dutch, Danish, French, Italian, Spanish - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info