756420
3
Zoom out
Zoom in
Previous page
1/17
Next page
EN 3
submerged waste water pump TWP 4025 E / TWP 7025 E / TWP 11025 E
General safety
Do not use the device in potentially explosive rooms or
areas and do not install it there.
Do not use the device in aggressive atmosphere.
Check accessories and connection parts for possible
damage prior to every use of the device. Do not use any
defective devices or device parts.
Before carrying out maintenance, care or repair work on
the device, remove the mains plug from the mains socket.
Hold onto the mains plug while doing so.
When positioning the device, observe the minimum
distances from walls and other objects as well as the
storage and operating conditions specified in the Technical
data chapter.
Do not remove any safety signs, stickers or labels from the
device. Keep all safety signs, stickers and labels in legible
condition.
General safety warnings – Electrical safety
The device is to be supplied with a rated residual current
of no more than 30mA by means of an RCD (Residual
Current protective Device).
Ensure that all electric cables outside of the device are
protected from damage (e.g. caused by animals). Never
use the device if electric cables or the power connection
are damaged!
The electrical connection must correspond to the
specifications in chapter Technical data.
Insert the mains plug into a properly secured mains
socket.
Switch the device off and disconnect the power cable from
the mains socket when the device is not in use.
Do not under any circumstances use the device if you
detect damages on the mains plug or power cable.
If the connection line of this device is damaged, the device
must be sent for recycling in accordance with the
specifications provided in the Disposal chapter.
Defective power cables pose a serious health risk!
Should there be a risk of flooding, install the plug
connections in a flood-proof area. There is a risk of
electric shock!
Make sure that the mains voltage corresponds to the
specifications on the nameplate.
Have all electrical installations carried out by an expert
according to the national regulations and the device-
specific requirements.
Do not use the power cable to drag the device.
Hold onto the mains plug while pulling the power cable out
of the mains socket.
Protect the power supply cable against heat, oil and sharp
edges. Make sure that the power supply cable is not
crushed, kinked or subjected to other mechanical stresses.
Only use splash-proof extension cables intended for
outdoor use whilst observing the device's power input.
Before using cable drums, always unroll the cable
completely. Check the cable for damage. The use of
extension cables which are not approved for outdoor use
can result in injuries due to electric shock.
Before performing any work on the device, in case of leaks
in the water system, before taking work breaks or when
not in use, remove the mains plug from the mains socket.
General safety warnings – Personal safety
Never use the device with persons or animals in the water
or pumping medium or if they could access it. There is a
risk of electric shock!
Never insert any objects or limbs into the device.
This appliance is not a toy! Keep away from children and
animals. Do not leave the device unattended during
operation.
Device-specific safety warnings for submerged
pumps
Do not leave the device running unattended to ensure an
early detection of when the device runs dry or switches off
automatically. This would damage the device. Regularly
check the float for proper functioning.
Please bear in mind, that the device is not suitable for
continuous operation (e.g. for watercourses in garden
ponds). Check the device for proper functioning on a
regular basis.
Keep in mind, that lubricants are used within the device.
These might potentially cause damages or contaminations
if emitted. Do not use the device for drinking water or in
garden ponds with either a fish population or valuable
plants.
The device is not to be carried by holding it at the power
supply cable or hose. Do not fasten it there either.
Do not place any objects on the device – not even to
weight it down. The device will sink to the ground due to
its own weight.
After the set-up of the device, its mains plug must be
readily accessible during operation.
Wear sturdy shoes to protect yourself against electric
shock.
Provide appropriate frost protection.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Trotec TWP7025E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Trotec TWP7025E in the language / languages: English as an attachment in your email.

The manual is 2,35 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Trotec TWP7025E

Trotec TWP7025E User Manual - German - 17 pages

Trotec TWP7025E User Manual - Dutch - 17 pages

Trotec TWP7025E User Manual - French - 17 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info