753923
5
Zoom out
Zoom in
Previous page
1/9
Next page
EN 5
LED work lamp PWLS 01-3
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Before transporting the device, observe the following:
Switch the device off.
Allow the device to cool down.
Remove the batteries from the device.
Observe the following when transporting or shipping batteries:
The user may transport the batteries by road without any
additional requirements.
Only ship batteries if their housing is undamaged.
Mask open terminals with tape and pack the battery in
a way that it cannot move inside the packaging.
Please also observe any other national regulations.
Storage
Before storing the device, proceed as follows:
Switch the device off.
Remove the batteries from the device.
Clean the device as described in the Maintenance chapter.
When the device is not being used, observe the following
storage conditions:
dry and protected from frost and heat
Ambient temperature below 75°C
protected from dust and direct sunlight
Start-up
Unpacking the device
Take the device and the accessories out of the packaging.
Warning of electrical voltage
Electric shock from insufficient insulation.
Check the device for damages and proper functioning
before each use.
If you notice damages, no longer use the device.
Do not use the device when the device or your hands
are damp or wet!
Check the contents for completeness and look for
damages.
Warning
Risk of suffocation!
Do not leave the packaging lying around. Children may
use it as a dangerous toy.
Dispose of the packaging material according to the
national regulations.
Inserting the batteries
You need 3AA batteries for the device PWLS 01-3.
Insert the batteries into the device prior to use. To do so, please
proceed as follows:
1. Open the battery compartment(3) at the front of the device
by pulling down the battery compartment cover(3).
2. Insert the batteries with correct polarity(+/-).
3. Close the battery compartment(3).
Remove batteries
1. Open the battery compartment(3) at the front of the device
by pulling down the battery compartment cover(3).
2. Remove the batteries from the device.
3. Put the battery compartment cover(3) back on the device.
4. Dispose the batteries properly.
3
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Trotec PWLS 01-3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Trotec PWLS 01-3 in the language / languages: English as an attachment in your email.

The manual is 0,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Trotec PWLS 01-3

Trotec PWLS 01-3 User Manual - German - 10 pages

Trotec PWLS 01-3 User Manual - Dutch - 10 pages

Trotec PWLS 01-3 User Manual - French - 10 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info