Manual Trixie 24383 - TX6 (page 3 of 9) (English, French, Italian, Polish, Portuguese, Spanish)

588887

Zoom out

Zoom in

1/9

Automatic Food Dispenser TX6

Instructions

Warning

Please read the instructions fully before you start opera-

ting the device.

Installing batteries:

1. Unlock the cover with the release knob and lift it off.

The battery compartments are on the underside of the

cover.

2. Remove the battery covers and install four new Alkaline

batteries Baby C.

3. Replace the battery covers. Make sure that the covers

snaps securely into place.

4.Place the device securely on even ground.

Turning the device on:

1. Open the cover of the control panel and switch the device

on or off with the ON/OFF button (the round button on

the left).

2. When the device is switched on, the time will automati-

cally ﬂash at ‘12:00 A.M.’.

3. Every time a button is pressed, the automatic food

dispenser conﬁrms this with a beep. First press the ENTER

button to set the current time. The hour ﬂashes.

4. Use the arrow buttons to set the hour. During setting,

the time changes automatically between A.M. (morning

to noon) and P.M. (afternoon to midnight).

5. After you press ENTER again, the minutes start ﬂashing.

6. Use the arrow buttons to set the minutes.

7. When the time is correct, end the setting process by

pressing ENTER.

Choosing the meal:

1. Keep ENTER pressed for 3 seconds. Now MEALS begins to

ﬂash, and you are in the meal setting mode. Press ENTER

again and BREAKFAST ﬂashes.

2. Use the arrow buttons to choose the meal that you want

to programme. BREAKFAST, LUNCH and DINNER will

ﬂash one after the other when the arrow buttons are

pressed.

• The programming has to be completed within 10 minutes.

If this is not the case, the red LED light continues to ﬂash

to remind you that the setting has not been completed.

If you do not attempt a new setting, the device will work

according to the existing settings. If you have not set any

meal, the device works according to the preset times

(6:00 A.M., 12:00 P.M., 6:00 P.M.). This ensures that your

pet is not left hungry with no food at all.

• If the meal size is 240 ml or less, one cavity is enough to

serve the desired meal. If the meal size is more than

240 ml, e.g. 360 ml, you need 2 cavities, one full and one

half full.

• If the meal size is more than one cavity, there is a waiting

time of 10 minutes before the next cavity opens.

Changing the programming:

• If you want to change the programming, keep ENTER

pressed for 3 seconds. MEALS ﬂashes and you are in

setting mode. Press ENTER again and you can change the

settings for the meals with the arrow buttons.

• If you want to change the time, keep ENTER pressed for

3 seconds. MEALS ﬂashes and you are in setting mode.

Now press the downward arrow. When the time ﬂashes,

press ENTER again. Now you can set the time with the

arrow buttons.

Changing the batteries:

When battery power is low, the red LED light ﬂashes

slowly (once per second). Then the batteries have to

be changed. When you are away for a longer time, you

should change the batteries before you leave. Important:

after changing the batteries, you have to turn the device

on again and set the time anew. The meals you have pro-

grammed are saved in the device.

Cleaning:

The bowls can be washed by hand with a mild washing-up

liquid. The top can be wiped with a soft cloth and a mild

cleaning agent. It must not be submerged in water, as this

could lead to short circuit or electric shock and damage

electronic components. Leave all parts to dry well before

you ﬁll in new food (but not exposed to sunshine).

Trouble shooting:

• If the display does not light up, turn the device on again.

(See corresponding section in these instructions)

• If the time ﬂashes, there was a power failure and the time

has to be set anew (see corresponding section in these

instructions). The programmed meal times do not have to

be set again.

• If the red LED light ﬂashes:

• Fast ﬂashing (3 times per second) means error. You

should check the device, possibly food has blocked a

cavity.

• Slow ﬂashing (once per second) indicates low battery

power. Change the batteries, turn the device on and set

the time anew.

3. Press ENTER when you have chosen the meal you want.

a. Then YES will ﬂash. Now press ENTER if you want to set

the time for the meal.

b. If you do not want to set the time for this meal, use the

downward arrow to choose NO and then press enter.

Please note: If NO is chosen, the software will go back to

MEALS. Use the arrow buttons to choose the meal that

you want to programme.

Feeding times:

After you have chosen the MEAL and selected YES, the

hour ﬂashes.

1. Use the arrow buttons to set the hour for the meal.

2. Please note: during setting, the time changes automati-

cally between A.M. and P.M.

3. Press ENTER again and the minutes start to ﬂash.

4. Use the arrow buttons to set the minutes for the meal.

5. Press ENTER when the minutes have been set. The menu

then automatically continues to setting the meal size

(BOX).

Setting meal size:

After you have set the feeding time, the menu for setting

the meal size ﬂashes (on the right on the display).

1.Set the meal size that is to be served with the arrow

buttons. For each meal, you can choose 1, 2 or 3 BOX

(food units). One food unit is one of the six cavities in the

device (approx. 240 ml or 1 US cup each). If you choose

two or three food units for a meal, the cavities will open

one after the other with an interval of 10 minutes.

2. Press ENTER to end the setting.

Setting other meals:

Repeat the programming as described above for each

meal. After you have programmed all meals, press ENTER

until the device beeps twice. That means your settings are

conﬁrmed.

Important:

• The counter SERVED shows how many food units have

been served. Once all 6 food units have been served, the

red LED light ﬂashes slowly and new food has to be ﬁlled

in. After ﬁlling the device, press START and the device will

work according to the programming. The counter goes

back to zero.

• After programming, make sure that the cover over the

control panel is securely fastened so that your pet cannot

change the settings by accident.

Extra option manual feeding: Keep the down arrow

pressed for 3 seconds. This releases one food cavity

immediately.

Information:

• The following feeding times are preset: breakfast at 6:00

A.M., lunch at 12:00 P.M. and dinner at 6:00 P.M.

• Very slow ﬂashing (once every 5 seconds) means that all

6 cavities have been served and new food has to be ﬁlled

in. After ﬁlling the cavities, press START. Then the device

will work according to the programming.

• Remove all packaging before you use the device, dispose

of all packing material properly. Some items may be

packed in poly bags. Danger of suffocation, keep out of

reach of children and pets.

• Read the instruction carefully before operating the device.

Wrong settings may lead to your pet not being fed

properly or not being fed at all.

• This feeder is for indoor use only.

• Place the feeder in a dry place on even ground.

• Do not place the feeder in a closet, in a narrow space or

close to a wall, as the top section of the feeder will rotate

to expose the food trays. Placing the feeder where there is

too little space around it may make it difﬁcult for your pet

to access the food.

• Do not allow children to play with the feeder. Settings

may be changed or the feeder might work faultily or stop

working. Adult supervision is required when children are

near the device.

• Do not try to disassemble the feeder.

• Remove all batteries if you do not use the feeder for a

longer time.

• Do not use different types or different brands of batteries.

24383_Anl_210x285.indd 4-5 17.03.15 11:38

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Trixie 24383 - TX6 in the language / languages: English, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 0,78 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Trixie 24383 - TX6 Manual

Product: