530932
4
Zoom out
Zoom in
Previous page
1/80
Next page
4
* Competent qualified repair service: after sales department of the producer
or importer or any person who is qualified, approved and competent to
perform this kind of repairs in order to avoid all danger. In any case you
should return the appliance to this repair service.
IMPORTANT
• Read the operating instructions carefully in order to get to know the
equipment before putting it into operation.
• Keep the instructions for future reference.
INSTALLATION OF THE APPLIANCE
• Install the appliance on a firm, horizontal surface. To level the
appliance, use a spirit level or a vessel containing water, if necessary.
• Avoid installing the appliance in direct sunlight or near any source of heat.
• The distance between the rear of the appliance and a wall shall not be
less than 10 cm, and the minimum ventilating space from the sides of
the appliance shall never be less than 5 cm.
• In all cases, the location shall be protected from rain and splashing.
• To guarantee a good level of air circulation, do not obstruct the
ventilation grids of the upper, lower or rear surface of the appliance.
• Complying with the above will ensure efficient and economical cooling.
• Before the first use of the appliance, clean the inside and the cover of
the appliance with warm water, adding detergent if necessary. Never
use an abrasive product.
OPERATION WITH THE MAINS 220  240 V
• Never use another source of energy at the same time (battery, gas).
• Check that the mains voltage corresponds to the operating voltage
specified on the label (on the rear of the appliance).
• If the electrical specifications are correct, push the safety electrical plug
into an earthed wall socket which is wired according to the specifications.
STARTUP
• Turn the thermostat knob clockwise to the MAX position. The effects of
the cooling process (frost on the evaporator) only become visible after
about an hour.
• The thermostat enables the temperature of the cool box to be
adjustable (“0”=cooling process stopped).
• After a sufficient cooling period (approximately 5 hours), the
thermostat can be set to an intermediate position. The selected
temperature is regulated automatically by the thermostat.
Shut-down
• Turn the thermostat knob anti-clockwise to the “0” position.
• Remove the plug from the wall outlet.
OPERATION WITH A BATTERY 12V
• Do not use another source of energy at the same time (mains, gas).
• A safety fuse must be installed in the power supply line between the
battery and the cool box. For 12V, the maximum fuse rating is 6,25 A.
Cable cross-section Max. cable length
2.5 mm
2
2.5 m
4.0 mm
2
4.0 m
6.0 mm
2
6.0 m
• It is not necessary to check the polarity when starting up the appliance.
• Check that the battery voltage corresponds to the operating voltage of
the cool box, as marked on the corresponding the label.
Instruction manual
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Tristar KB-7146 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Tristar KB-7146 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Swedish, Spanish as an attachment in your email.

The manual is 0,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info