For all PTG+/Junior/Tailgater/Century/Lonestar/Lil Tex
Texas/XL/Select/COM models
Tools required:
1/4” wrench, socketor nut driver.
WARNING! Before installing or maintaining electrical parts inany Traeger Pellet Grill, disconnect power from the
source. Hazardous voltage may bepresent which can shock, burn, or cause injury or death.
If you need any assistance while replacing parts, please contact Traeger Customer Service at 1-800-872-3437 between
5AM and7PM Pacific, 7 days a week.
Removal steps:
1.Unplug the cord from the electrical outlet.
2.Remove any guards and panels that block access to the fan motor. This mayvary from model to model.
3.Unplug the plastic Molex connector located on the end of the fan motor from the connector on the controller
with the orange and white wires. See Figure 1.
4.Remove the four (4) Tek screws from below. Remove the fan motoras shown in Figure 2.
(Note: For COM200 and BBQ150 models, the fan is mounted on the side of the burner, butremoval is otherwise
the same)
Figure 1Figure 2
Replacement steps:
1.Place replacement motor under hopper/burner assembly as shown in Figure 2.
2.Insert the four Tek screws through the brackets on the fan and into the bottom of the hopper/burner assembly.
Do not overtighten.
3.Turn fan blade by hand to ensure that fan turns freely.
4.Plug the male Molex connectoron the fan motor into the female connector on the controller with the orange
and white wires. Use the included wire ties to secure the wires so they do not interfere with any moving parts.
5.Replace any guards or panels if needed.
6.Plug in the grill and set the control to Smoke to verifythat the fan spins.
Need help? Post your question in this forum.
Report abuse
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Traeger FAN209 - Induction fan at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Traeger FAN209 - Induction fan in the language / languages: English as an attachment in your email.
The manual is 0.17 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
The manual is sent by email. Check your email
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.