772886
1
Zoom out
Zoom in
Previous page
1/2
Next page
Product Introduction
Replace your traditional 3-way switches commonly found in living rooms, hallways, or stairways
where two switches control the same light. Dim the light from 100% to 1% via your phone or
simple voice commands to set the perfect ambiance for any activity.
* You can nd step-by-step instructions in the Kasa Smart app.
1) Turn o the circuit breaker.
2) Remove the old wallplate, and take
a picture of the wires in case you want
to go back to the old switch.
Connect the wires to the main dimmer
switch as shown below.
Install the Satellite dimmer switch to the
other wallbox by connecting the wires as
shown below.
5Connect the wires to the satellite dimmer
switch as shown below.
7
Secure the dimmer switch with screws.
6
Identify and label other wires.
4Secure the dimmer switch with screws.
8
Identify Line wire to locate the main switch.
3
1) Disconnect the wires from the two
old switches. Make sure they’re not
touching when circuit breaker is on.
2) Turn on the circuit breaker and use
a voltage detector to identify the
energized wire (line wire).
3) Turn o the circuit breaker and label the Line wire.
4) Check if there is Neutral wire in the
wall box with Line wire. If yes, label
the Neutral wire. This wall box is the
place for the Main dimmer switch.
The other is for the Satellite dimmer
switch. If not, you cannot install the
smart dimmer switch here.
Main switch Satellite switch
Take care to avoid electric shocks.
Ground
Traveler 1
Line
Traveler 2
Neutral Ground
Traveler 2
Load
Traveler 1
Do not cross Traveler 1 and Traveler 2
wires between the two dimmer switches.
Brightness Indicators
Dimmer Buttons
On/O Button
Wi-Fi LED
On/O LED
Reset
Restart
Wire Your Switch
Remove the two old switches.
1) Turn o the circuit breaker.
2) Remove the old wallplates.
3) Take a picture of the wires in case you
want to go back to the old switch.
1
Line: Usually black. One end is connected to the circuit
breaker, the other to your rst 3-Way switch.
Neutral: Usually white, not connected to the dumb switch.
Traveler 1 / 2: Usually one is black and the other is red.
They connect the two 3-Way switches.
Ground: Usually green or copper. Ground wire is needed
if you use a metal wallplate.
Load: Usually black. One end is connected to the light
xture, the other to your second 3-Way switch.
Get to know the wires.
2
Flip the page over to complete setup.
If you are unsure, consult a qualied electrician
or contact our technical support.
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for TP-LINK KS230 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of TP-LINK KS230 in the language / languages: English as an attachment in your email.

The manual is 0.74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info