650602
13
Zoom out
Zoom in
Previous page
1/16
Next page
Tilt
REPLACING THE IGNITER COIL
WARNING: Before replacing the igniter coil, allow the heater to cool completely.
1. FIRST CHECK THE BATTERIES
When the igniter coil no longer glows sufficiently to light the wick,
replace the batteries. If proper glow is not restored, the igniter coil
may be defective.
2. CHANGE THE IGNITER COIL
Remove the batteries from the battery holder.
Release the automatic extinguisher, and remove the heat chamber
as described in Items 1 and 2 of the preceding section.
Note that the igniter coil fits into a bayonet socket the same way a
flashlight bulb fits into its holder.
To remove the igniter coil, push it in and twist in either direction
while holding the sides of the socket with your other hand.
Install the new igniter coil by pressing it into the socket and turning.
Replace the heat chamber, and reinstall the batteries.
STORAGE
At the end of each heating season, or when you do not plan to use your heater for an extended
period of time, the following procedures are recommended:
1. DRAIN FUEL SUB TANK
After you have burned your heater dry, a small amount of kerosene
(paraffin) will remain in the fuel sub tank. It should be removed in
odor to avoid contamination when the heater is refueled at a later
date. To do this, disassemble the heater as described in items, I
throng 4 under “REPLACING THE WICK”. Remove the fuel
acceptance fitting from the hole in the fuel sub tank.
Tilt the drip tray toward the hole, and remove the remaining kerosene
(paraffin) with a siphon or a small syringe.
Replace the fuel acceptance fitting.
Replace the cabinet and the heat chamber.
2. REMOVE BATTERIES FROM BATTERY HOLDER
3. STORE HEATER
The original shipping carton is the best place to store your heater. If
you do not have original packing materials, cover the heater with a
large plastic bag and store in a dry place.
12
RCA-2800 Type C_US 14.7.10 11:17 ページ 12
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Toyotomi RCA-2800 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Toyotomi RCA-2800 in the language / languages: English as an attachment in your email.

The manual is 1,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info