650608
16
Zoom out
Zoom in
Previous page
1/20
Next page
AFTER REPLACING THE WICK, CHECK THE OPERATlON OF THE AUTOMATlC
EXTINGUISHER.
Wick height on position 1 of the wick life extender should be 8mm when wick
adjuster knob is turned fully cIockwise. Be sure to check.
NOTE: Remember always to start a new wick on position 1 of the wick life
extender.
NOTE: lf wick does not move smoothly and easily, or wick height on position
1 of the wick life extender is not in the range of 7-9mm do not use
heater. Disassemble and repeat items 5 through 10.
NOTE: lf any ragged edges appear on the top of the wick, trim them with a
scissors carefully. DO NOT cut the body of the wick.
11. Replace the heater cover on the fuel tank and secure it into position with three
(3) screws.
12. Once again, check the proper operation of the automatic extinguisher.
NOTE: Before lighting a new wick for the first time, turn the wick to its
lowest position and allow the wick to saturate with kerosene
(paraffin) for about thirty (30) minutes.
REPLACING THE IGNITER COIL
USE ONLY GENUINE TOYOTOMI REPLACEMENT IGNITER COIL. SUBSTITUTE IGNITER COILS CAN
SEVERELY REDUCE PERFORMANCE AND SAFETY.
1. REPLACE BATTERIES
When the igniter coil no longer glows sufficiently to light the wick, replace the batteries. If proper glow is
not restored, the igniter coil may be defective.
2. CHANGE IGNITER COIL
a) Remove the batteries from the battery holder.
b)
Disassemble the heater as described in items 1 and 2 of the preceding section.
c)
Remove the three (3) screws and heat release plate off.
d) To remove the igniter coil, push it in and twist in either direction while holding
the sides of the socket with your other hand.
e) Install the new igniter coil by pressing it into the socket and turning.
f)
Make sure that the position of tumor of heat release plate to be right side as
described in the illustration and tighted the three (3) screws.
g) Insert the (2) batteries according to the plus (+) and minus (–) markings inside the holder.
h) Reassemble the heater as described in item 11 of the preceding section.
14
WARNING: To avoid contact burns, allow your heater to cool completely before replacing the igniter.
KS-47B_US.qxd 14.7.25 13:18 ページ 14
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Toyotomi KS-47B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Toyotomi KS-47B in the language / languages: English as an attachment in your email.

The manual is 1,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info