627009
33
Zoom out
Zoom in
Previous page
1/33
Next page
7. APPENDIX (M-T51/T51A PRINTER SPECIFICATIONS)
EO18-11004A
7.3 Paper Specifications
7- 3
7.3 Paper Specifications
Do not store the paper for longer than the manufacture’s recommended shelf life.
Store the paper in a cool, dry place. Avoid areas where they would be exposed to direct sunlight,
high temperature, high humidity, dust or gas.
A contact of chemical or oil may discolor or erase the printed record.
Rubbing the paper hard with nail or hard object may discolor the paper.
The paper end should not be pasted to the core.
1) Paper width 57.5
±
0.5mm
2) Outer roll diameter Up to
80mm
3) Paper type Only paper rolled onto a core is acceptable, however, the paper end
should not be pasted to the core.
Thermal paper rolled with the print side facing outside.
Recommended paper type: KF50 (KANZAN)
TF50KS-E2C (Nippon Paper Industries)
P-350 (KSP)
7.4 General Maintenance
1) Cleaning the thermal head and the platen
In case paper particles and dust are attached to the element of thermal head, clean the thermal
head and the platen in the following procedure. Failure to do this may lower the print quality.
(1) Raise the Paper Free Lever to separate the thermal head from the platen.
(2) Carefully clean the element of thermal head with a cotton swab slightly moistened with alcohols
solvent such as ethanol, methanol, and IPA. (Use of chemicals excepting alcohols solvent may
damage the thermal head.)
(3) Make sure that alcohols solvent fully evaporated, and then return the Paper Free Lever to return
the thermal head in the original position.
2) Removing jammed paper
(1) Cut the paper at the paper inlet.
(2) Raise the Paper Free Lever to seprate the print head from the platen.
(3) Carefully pull out the remian of paper straight from the paper outlet.
CAUTION!
Use only paper which meets specified requirements. Use of non-specified paper may shorten the
head life of the printer, result in problems with print quality, or cause a paper feed failure. All paper
should be handled with care to avoid any damage to the paper. Read the following guideline
carefully.
CAUTION!
NEVER touch the thermal head, the portion near the thermal head, and the motor surface being hot
during printing and just after printing. Do not touch the thermal head by hand, a screwdriver, and
tweezers, etc.
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Toshiba TEC FS-1535 SERIES at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Toshiba TEC FS-1535 SERIES in the language / languages: English as an attachment in your email.

The manual is 0,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info