The wheel perimeter has been set according to client’s requirements.
7. ALARM
The monitor will “Beep” when press “MODE” “RECOVERY/UP” “DOWN”, RESET/GO or
“BODYFAT” buttons.
8. AUTO ON/OFF & AUTO START/STOP
i. Without any signal of exercise or operation for 8 minutes, the power will turn off automatically and
all the memory will be cleared off except body fat parameters and temperature.
ii. Once receive exercise or operation signal, the monitor will turn on automatically.
OPERATION
1. SET
Press MODE to choose the display window that needs to be pre-set, and the value in relevant window will
flash. Then press UP/DOWN to increase/decrease the value to reach your want alarm time, alarm distance,
or alarm calorie. Hold UP/DOWN to increase/decrease the value rapidly. Press RESET to reset value in
relevant flashing window.
2. PULSE RATE
Before measuring your pulse rate, press any button to change “P” into “” in the window, then enter pulse
mode. Please place both your palms on the contact pads and the monitor will show your current heart beat
rate in beats per minute (BPM) on the LCD after 3~4 seconds.
Remark: During the process of pulse measurement, because of the contact jamming, the measurement
value may be higher than the virtual pulse rate during the first 2～3 seconds, then will return to normal
level. The measurement value cannot be regarded as the basis of medical treatment.
3. PULSE RECOVERY
In non-setting and non-exercising status, first test your pulse as above mentioned. Then press
RECEOVERY/UP to enter pulse recovery function. The display will show 1 minute count-down as well as
your pulse rate. Hold on the pulse sensor until it counts down to zero. Then, it will pop up your pulse
recovery level from F1 to F6, that is, from the fastest recovery to slowest. The fastest recovery F1 show
the best. Press RECOVERY/UP again to exit pulse recovery function.
4. BODYFAT, BMI & BMR
In non-exercising status, press BODYFAT to enter body fat parameters settings. You can set from the
below sequence: exerciser No.( 1 ~ 8 ), weight( KG ), height( CM ), age ( YEAR ), gender. But, if the
meter showing M, the weight will show “lb”,while height will show “in”.Press MODE to proceed to next
parameter setting. Press RECOVERY/UP to increase the setting value while press DOWN to decrease.
When you finish setting, hold the pulse sensor and press RESET/GO. Then the display will show your
body fat in 6 seconds.
Press BODYFAT again to exit body fat test.
Remark:
i. During parameters setting, it will exit body fat test automatically if detects no operation signal over
10 seconds.
ii. During body fat test, it will display Er.1 if sense no test target over 10 seconds.
5. AUDIO AMPLIFIER AND SPEAKER [ IF HAVE ]
Connect the audio input plug to the audio player, the turn on the audio switch that in right side of the
computer. In that case, the audio can be in play.
BODYFAT CONTRAST
