Manual Toolland TC80100 (page 3 of 21) (English, German, Dutch, French, Portuguese, Spanish)

622633

Zoom out

Zoom in

1/21

TC 80100

Toolland | www.toolland.be 3

standards need to be complied with when

installing the appliance.

 The installation of the smoke outlet must

be as vertical as possible, avoiding the

use of joints, angles and deviations.

 If the installation is connected to a

masonry chimney pipe we recommend

the tubes reach the exterior exit. If the

smoke outlet is via tubing only at least

three meters of vertical tubing are

recommended.

 Important: the installation of this stove

must be carried out by a qualified

professional.

 The ventilation opening must never be

obstructed.

 Important: the woodstove must be

installed in a well ventilated place.

 It is advisable to have at least one

window in the same room as the stove

which can be opened.

 The tube connections should be sealed

with a refractory putty to prevent soot

from falling through the joints.

 Do not position the stove near

combustible walls. The stove should be

installed on a non combustible floor

surface, if not a metal plate covering the

bottom surface area of the stove must be

placed underneath it and extend further

than 15 cm at the sides and 30 cm at the

front.

 Whilst the stove is in use remove any

material nearby which could damaged by

the heat: furniture, curtains, paper,

clothes…

 Please consider keep ease of access for

the cleaning of the product, smoke outlet

and chimney smoke outlet.

 If you intend to install your stove near an

inflammable wall we advise you to leave

a minimum distance to facilitate cleaning.

 This stove is not suitable for installation

in any chimney system shared by other

sources.

 The stove should be installed on flooring

with adequate support.

 If your current floor does not comply with

this criterion, it should be adapted with

appropriate measures (for example a

weight distribution plate).

FUEL

 Use only dry wood with a maximum

moisture content of 20%.

 Wood with a moister content higher than

50 or 60% does not heat and combusts

very badly, and creates a lot of tar,

releases excessive amounts of vapour

and deposits excess sediments onto the

stove, glass and smoke outlet.

 The fire should be lit using special fire

lighters, or paper and small pieces of

wood.

 Never try to light the fire using alcohol or

similar products.

 Do not burn plastic materials or greasy

products that can pollute the

environment and lead to risks of fire due

to obstruction of the pipes.

TECHNICAL SPECIFICATIONS

capacity

125 m²

steel thickness

1.5 mm

total height

70 cm

smoke outlet diameter

12 cm

weight

42 kg

heat resistant paint

800 °C

dimensions:

upper chamber

50.5 x 20 x 20 cm

lower chamber

61.5 x 30 x 30.5 cm

MAINTENANCE

 Never clean the stove while it is in use.

 It is also important to clean the smoke

outlet tubing periodically and check there

are no blockages before relighting fuel

after a long period of non-use.

 At the start of each season a professional

should carry out a revision of the

installation.

 In the event of a fire in the smoke outlet,

close all air draughts if possible and

contact the authorities immediately.

 Any replacement parts which you may

need must be recommended by us.

WARRANTY

Refer to the enclosed guarantee conditions

for the terms and conditions of guarantee.

ENVIRONMENT

Should your device need replacement after

extended use, do not put it in the domestic

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Toolland TC80100 in the language / languages: English, German, Dutch, French, Portuguese, Spanish as an attachment in your email.

The manual is 0,78 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Toolland TC80100 Manual

Product: