ALICANTE, VALENCIA, ALMERIA
3
Damaged or nonoperational fireplace insert cannot be used. The user must provide its professional repair before using it again.
Ash accumulation in smoke tubes and bends must be checked at least once a month and cleaning provided when required.
During operation, all air supplies to fireplace insert must not be closed.
During operation, it is necessary to monitor the functions of the fireplace insert and the fire safety. You must check the amount of fuel in
the hearth, sooting of the grate, conditions of control mechanisms of combustion air, if the door is closed and if the surrounding is clean.
Broken vermiculitte brick in hearth is no obstacle to further use of fireplace insert. This does not apply to ceiling vermiculite.
When used simultaneously with other heating device, proper area venting must be provided (see part 1.4).
2.2 Fuel
This fireplace insert is intended for use of: wood, brown-coal briquettes 7”, 6” long.
Emission standard dictates that only naturally dried wood (humidity content max. 20%) can be used. Wet wood causes strong tar
condensation. The most suitable are wooden logs with diameter of 30 cm and 30 cm long, stored in dry place for at least 2 years. Most
suitable are: beech, oak, hornbeam, birch and fruit trees wood.
Only fuel mentioned above can be used.
Unacceptable for use is also: carbon grit, finely chopped chips, bark and chipboard waste, wet wood and wood treated by a prophylactic,
paper and pasteboard (except heating up).
Waste combustion is forbidden by Law of protection against emissions.
Combustion gases produced by waste combustion can threaten your health and cause damage to chamotte and metal parts of your
fireplace insert and to your chimney.
2.3 Fire inserts setting
The fireplace insert has one control valve for air supply and control of primary and secondary air flow situated under the door.
NOTE: the control mechanisms can be very hot! Use the glove supplied as an accessory for manipulation of hot objects.
2.4 Heating up
Before heating up you must open air supplier. At the same time, ensure air supply to the room (see part 1.4). Recommended fuel should
be supplied at the nominal thermal power in intervals of one hour.
Fire is set up using paper and thin wooden chips. Never use petrol, alcohol, kerosene, etc. Place a layer of wooden logs and briquettes
on the fire.
Never use more than three wooden logs as fuel load.
When using the fireplace insert for the first time, heat it up with a small fire. First, wait until the fire becomes bigger so that the fireplace
insert could slowly and evenly extend and the fireplace body will not suffer any damage due to temperature tension.
In case of difficulties with heating up (weather changes, cold chimney, etc.), local fire is set up in the fireplace insert using paper to heat
it up better. During heating up it is necessary to check on the combustion and constantly monitor the fireplace insert. The fireplace insert
is covered with heatproof paint that hardens at higher temperatures. Therefore smell is produced during the first phase of heating up. For
this reason, especially at the first use, sufficient venting must be provided. We do not recommend touching the external paint of the
fireplace insert when using for the first time, because it is not yet hardened and it could be damaged.
2.5 Normal operation
Nominal heating capacity of fireplace heater is 8,0 kW and it is obtained at minimum supply pressure of 10 Pa.
