582508
7
Zoom out
Zoom in
Previous page
1/9
Next page
TD 190_E 7
Mounting or exchanging a pick-up cartridge
Instead of the factory-supplied pick-up cartridge any
other cartridge with standard half-inch mounting
holes and a weight between 3 and 10 grams can be
installed. To do this loosen the collar-lock (9) and
pull off the head shell (Fig. 7). Unscrew the cartridge
and carefully remove the coloured signal leads from
the cartridge pins with a pair of tweezers. Screw the
new cartridge onto the head shell but do not tighten.
Attach the leads to the pins while observing the
correct coding.
Fig. 7
Please note: The example shown in Fig. 8 is appli-
cable only for the pick-up cartridge OMB 10!
For the precise adjustment of the so-called stylus
overhang push the head shell with cartridge into the
supplied mounting gauge. The adjustment is correct
if the stylus is flush with the V-shaped recess in the
gauge as viewed from above. When viewed from the
side the stylus should be seen within the rectangular
recess of the gauge (Fig. 9). Adjust the cartridge in
the head shell until the correct positions are
achieved. Lastly, tighten the mounting screws, put
the head shell with cartridge back on the tone arm
and tighten the collar-lock (9).
ATTENTION!
During these mounting and adjustment procedures
Fig. 8
you must be very careful not to damage the delicate
stylus and cantilever by uncontrolled and brisk
movements.
Replacing the stylus
Any stylus is subject to wear even under normal
playing conditions. Therefore, it is highly
recommended to have the cartridge, respectively its
stylus, inspected after about 500 hours of playing.
This is because a worn or damaged stylus will
eventually damage your precious vinyl records!
In order to playback vintage shellac records (78's)
with optimal results the original stylus should be
exchanged with a suitable special stylus for shellacs.
Please consult your THORENS dealer for further
information and details.
Fig. 9
R
=
right channel
RG = green right channel ground
L = white left channel
LG = blue left channel ground
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Thorens TD 190-1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Thorens TD 190-1 in the language / languages: English as an attachment in your email.

The manual is 0,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Thorens TD 190-1

Thorens TD 190-1 User Manual - French - 9 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info