658774
31
Zoom out
Zoom in
Previous page
1/34
Next page
A.1 TROUBLESHOOTING
P27
English
Problem Possible cause What to do
No sound or picture,
but the front panel
shows red light
The receiver is in standby
mode
Press the On/Standby button
No sound or picture,
but the receiver menu
can be seen on the TV
screen.
(Press MENU on the
remote control.)
The channel is o-air
The satellite dish is not
pointing at the (correct)
satellite.
Channels are deleted in the
edit menu
Try other channel(s).
Check the signal level in the
Antenna Setup menu. Adjust
the dish.
Scan for channels (again)
No signal or weak signal,
intermittent reception.
Cables might have loosened.
Moisture might have entered
into cables or connectors.
Heavy rain at present.
Heavy storm at present.
Check the cable connections, LNB
and other equipment connected
between the LNB and the receiver,
or peak the dish.
Wait for the rain/storm to subside
The satellite dish is not
pointing at the (correct)
satellite(s)
Adjust the dish. Ask a local satellite
specialist for advice.
Satellite dish is too small
Trees or buildings in path.
Change to a larger dish
Change position of the dish
The signal is too strong, the
dish is oversized.
Connect a signal attenuator to
the LNB input. Ask a local satellite
specialist for advice.
Bad picture/blocking
error during heavy rain.
Heavy rain will attenuate
satellite signals, below a
certain level blocking will
occur.
Make sure your dish installation is
up to standards to minimize rain
eects. When in doubt, ask a local
satellite specialist for advice.
The receiver switches o
after 3 hours of inactivity
of remote control
commands
The power saving Auto
Standby function is activated
Switch the Auto Standby function
o, if you don’t like it.
The receiver is suddenly
behaving unexpectedly
or erratically, for example
after a mains power
failure, power glitch,
lightning strike near you
or after a (interrupted)
software update.
Mains power problems could
cause a glitch in the software
in rare cases.
Load the factory setting from the
System menu.
If not recoverable, ask a local
satellite specialist for advice or
contact the local Service Hotline or
send email to our support via
www.thomsonstb.net.
31


Need help? Post your question in this forum.

Forumrules
1

Forum

thomson-ths221

Reset search

  • What is the 3 digit Code to use in a Universal Remote Control for a Thomson THS221 Satellite Receiver? Submitted on 18-9-2022 at 11:22

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Thomson THS221 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Thomson THS221 in the language / languages: English as an attachment in your email.

The manual is 1,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Thomson THS221

Thomson THS221 User Manual - German - 40 pages

Thomson THS221 User Manual - French - 34 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info