Manual Thetford C-250 (page 4 of 52) (English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish)

671564

Zoom out

Zoom in

1/52

- 4 -

by pressing the ﬂush button several times in a row.

Close the valve blade after use.

Note. To guarantee the best functioning of your Thetford

toilet we recommend to use Thetford additives and

Thetford Aqua Soft toilet paper.

Important Warning Notice! Please do not travel with a

ﬂush-water tank that is too full (we advise empty, but

for sure not ﬁlled more than half-full). Do not travel

with water in the toilet bowl. Failure to adhere to this

notice may result in water damage to your caravan or

motor home. Please avoid to travel with a waste-holding

tank that is more than 3/4 full. This may cause leakage

through the venting system.

Using the toilet with Additional Features

13. Electric blade opener: Push the electric blade button on

the control display to electrically open or close the blade.

In the case of failure, you can manually open or close the

blade by sliding the small handle under the toilet bowl

sideways.

Note. To guarantee the best functioning of the Electric

Blade Opener it should be operated without sitting on

the toilet.

14. Electric Ventilator: The ventilator automatically starts

when the control panel is activated (by pressing the

ﬂush button) and will automatically shut off after

approximately 5 minutes. The Electric Ventilator

Indicator will ﬂash until automatic shut-off occurs. If you

want to stop the ventilator, press the Electric Ventilator

button. If you want to re-start the ventilator, press the

button again (the LED will start ﬂashing again).

15. Flush-water tank level indicator (only for toilets with

own ﬂush-water tank): When the ﬂush-water tank level

indicator lights up, reﬁll the ﬂush-water tank, as only

about 1L of water is left in the tank, which is sufﬁcient

for approximately 2 ﬂushes.

EMPTYING

The waste-holding tank requires emptying when the red light

(LED) on the toilet control display lights up. The red light

lights up, when the waste-holding tank only has capacity for

approximately 2 more litres, which is no more than two to

three further uses.

Make sure that the blade is closed. Open the access door

located outside the vehicle, pull the safety catch on the

waste-holding tank upwards and remove the waste-holding

tank by pulling the tank towards you.

16. Place the waste-holding tank in an upright position

(pull-out handle at the top, wheels at the bottom).

17. Release the handle from the snaps, pull the handle up

and wheel the waste-holding tank to an authorized waste

disposal point.

18. Push the handle back into its locked position. Turn the

emptying spout upwards and remove the cap from

the spout. Hold the waste-holding tank in such a way

that during emptying you can operate the vent plunger

with your thumb. To empty the tank without splashing,

depress the vent plunger while emptying the tank. After

emptying, rinse the tank and blade thoroughly with

water.

Warning! Do not seriously shake the tank or use high

pressure water cleaners. This may cause damage to the

tank’s interior.

Note. The vent plunger should only be depressed once

the emptying spout is pointing downwards. Prepare the

toilet for re-use if required. Slide the waste-holding tank

into the toilet and close the access door.

Emptying with Additional Features

19. Waste-holding tank multi-level indicator: The lower LED

indicates that the waste-holding tank is almost empty;

the middle LED indicates that it is more than half full;

when the top LED is lit, the tank needs emptying as it

can only take 2 - 3 further uses.

Note. The red LED will ﬂash when the waste-holding

tank is not present or not in the right position.

20. Waste Pump-Out system: When activating the control

panel this feature automatically lights up. When the

waste-holding tank level indicator illuminates, press

the Waste Pump-Out button to pump out the waste

from the holding tank into the vehicle’s waste tank. The

button will ﬂash while the waste is being pumped and

will stop automatically (after approximately 2 minutes)

when all waste has been transferred. If the vehicle’s

waste tank is full, the Waste Pump-Out light will ﬂash

rapidly and no pump-out will be possible until the central

tank is emptied. (Check the level of the vehicle’s waste

tank regularly). After the waste-holding tank has been

emptied, there will be approximately 1.5 litres of waste

left in the tank. This is normal. Add 2 litres of water and

a correct dosage of Thetford toilet ﬂuids to the waste-

holding tank.

Important! Before activating the Waste Pump-Out

system, make sure that the central waste-holding tank

has still enough capacity (approximately 18L)

Important! For a proper breakdown of the waste

and functioning of the Waste Pump-Out system it is

important to use Thetford additives and Aqua Soft

toiletpaper.

Important! It is vital that the correct amount of Thetford

toilet ﬂuid is added to ensure the proper breakdown of

the waste in the waste-holding tank. Only use the system

when the waste-holding tank is ﬁlled. Using the system

too often on an empty waste-holding tank can cause

damage to the pump, which could cause the system to

fail.

CLEANING AND MAINTENANCE

The toilet should be cleaned and maintained regularly,

depending on the amount of use. To clean Thetford toilets,

we advise using water and Thetford Bathroom Cleaner

& Thetford Toilet Bowl Cleaner.

Note. Never use bleach, vinegar or other powerful household

cleaners that contain these substances. These may cause

permanent damage to the seals and other toilet components.

Hi. I have a thetford c250 cassette toilet. The bowl fills with water on its own. Is there a valve to replace? Submitted on 2-8-2020 at 04:04
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Thetford C-250 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 5,24 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Thetford C-250

Thetford C-250 Additional guide - All languages - 2 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Thetford C-250 Manual

Product: