Manual Thermocet VERSA LV-HV (page 3 of 14) (English)

607247

Zoom out

Zoom in

1/14

Page.3

We wish you happy heating with the purchase of this ThermoCet recessed gas fireplace. Please read

these instructions thoroughly before installing and using the fireplace. Keep these instructions care-

fully. Always state model and serial number in the event of a breakdown.

1. GENERAL

1.1 Delivery

You should inspect the appliance for damage in transit, immediately it has been delivered. If it is damaged,

you should report this without delay and as precisely as possible to your supplier. Please refer to the delivery

document.

1.2 Contents of packaging

1 x Completely assembled appliance

1 x Operation and installation manual

1 x Warranty card

1 x Pipe mouth with 4 self-tapping screws for connection of outlet

1.3 First firing

Your fireplace is coated with heat-resistant enamel that can withstand extremely high temperatures. Burn the

fire at high during the first hours of use and ventilate the room well. The curing of the enamel may produce a

smell/smoke, but this is harmless, however. Any marks on the glass can be removed immediately with glass

cleaner.

1.4 Guarantee ( see page 13 and 14)

Always complete your guarantee card in full and return it to your supplier immediately after purchase. Type

and serial number are shown on the plate that you will find on the bottom of the burner unit.

2. OPERATING INSTRUCTIONS VERSA

The Versa has a combined glow-effect and main burner (see page 10 figure 4). This burner can be operated

with either the thermostat knob (A) or the manual slide (B). You select the required setting with the thermo-

stat knob (A) and the modulating thermostat provides the right temperature. The hand-operated slide (B) al-

lows you to select the flame height you wish and the burner will continue to burn at that setting until you

change the selected setting.

2.1 Igniting.

* Open the gas stopcock fitted in the gas pipe to the appliance.

* Ensure that the thermostat knob (A) is at position n in the initial setting.

* Turn the thermostat knob (A) to the ignition position.ô

* Push the thermostat knob (A) and keep it pushed in.

* Push the ignition knob (C) all the way in until you hear a “click”; this is the spark ignition.

* You can see through the glass window whether the pilot light is burning. “Click” a few more

times if necessary, until the pilot light ignites.

* Keep the thermostat knob (A) pushed in for about another 30 seconds when the pilot light starts

burning and then release the knob.

* If the pilot light does not continue to burn, wait 5 minutes and then repeat the procedure.

* The burner is ignited by turning the thermostat knob (A) to the required setting (between set

tings 1 and 7, depending on the required temperature).

* To ignite the appliance with the glow-effect burner, move the slide (B) from position n depend-

ing on the required flame height (see figure). The glow-effect burner only functions when the

thermostat knob is between positions 1 and 7 (position 1 = low, position 7 = high).

Remark

Position (1) on the thermostat knob (A) is the pilot light setting if the room temperature is 10°C or more. If

the room temperature is below 10°C, the burner will also start to burn in position (1) until the temperature

has risen to 10°C.

Hi my versa lv fire would not stay lit, we have cleaned it and now it lights but only stays lit for about 30 seconds and goes out again. Does anyone have any advice? Submitted on 19-3-2022 at 12:34
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Thermocet VERSA LV-HV in the language / languages: English as an attachment in your email.

The manual is 0,46 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Thermocet VERSA LV-HV Manual

Product: