607258
5
Zoom out
Zoom in
Previous page
1/32
Next page
Page 5
3. REMOTE CONTROL
3.1 General
The unit is operated using a radio-controlled remote control. This consists of a manual transmitter and a
receiver. The receiver is connected to the gas control block.
* The receiver and gas control block are located at the bottom of the unit.
3.2 Manual transmitter
The transmitter uses a radio-controlled signal. The signal code is set at the factory, but can be adjusted if
required. (See 3.7)
3.3 Screen setup
After fitting the batteries, simultaneous pressing of OFF and
allows you to
change from °F (and 12-hour clock) to °C (and 24-hour clock), or vice versa.
Wait a moment or press OFF to return to MAN mode.
3.4 Time setup
* For SET mode or program mode, simultaneously press
and
* The time can be set while the screen is flashing.
* Press to input the hour and to input the minutes.
* Wait a moment or press OFF to return to MAN mode.
3.5 Setting the desired temperature
Press the SET -key briefly to select the required
mode or
Keep the SET –key pressed in until the screen starts flashing.
Subsequently press or to set the required temperature.
Wait a moment or briefly press the OFF -key to select the MAN mode.
If the temperature setting needs to be switched off with (low battery usage), then lower until
appears on the screen.
3.6 Setting the timer: P1 and P2
Press briefly on the SET -key to select the required mode
Keep the SET –key pressed in until P1
(heating period 1) flashes on the screen.
Set the commencement time of the first (1
st
) heating period by pressing on to input the hour, and on
to input the minutes.
Briefly press the SET -key; P1 now appears on the screen. Set the time the first (1
st
) heating period needs
to end.
Press the SET -key again to set the beginning and end of the second (2
nd
) heating period P2 (ON) and
P2 (OFF).
Wait a moment or press OFF to return to MAN mode.
Manual transmitter
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Thermocet Estilo at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Thermocet Estilo in the language / languages: English as an attachment in your email.

The manual is 3,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info