536957

Thane H2O mop X5 - KB-6622V Manual

16
Zoom out
Zoom in
Previous page
1/19
Next page
20
USER’S GUIDE
20
USER’S GUIDE
15
USER’S GUIDE
20
Never leave the H2O MOP X5™ unattended while  plugged in.
For Best Results:
1) Sweep or vacuum floor prior to using the H2O MOP X5™.
2) To avoid puddling of water, the Microfiber Cloth must
be clean and dry for use. To replace the cleaning cloth,
proceed as follows: Let the cleaning cloth cool down,
remove cloth from unit, replace with a new Microfiber Cloth
(Optional Item) and continue use. Select low steam regulator
position.
3) To sanitize an area of your floor, leave the H2O MOP X5™
at high steam setting over the steam area for about 10 seconds,
but no longer than 15 seconds.
Do not carry out this procedure on heat and steam
sensitive floors.
• Never steam at one spot for too long. This can cause floor
surface damage.
• Do not put hands or feet under the steam mop. Unit gets very hot.
• During use a pulsing noise may be heard indicating that the mop is producing
steam. This noise is normal.
• There may be some minor “spitting” of water mixed with the steam. This is
also normal.
• The force and heat of the steam may adversely affect certain materials. Always
check the suitability of using the steam mop on a surface by carrying out a
preliminary test on a hidden area.
Thane Direct and its affiliated companies assume no liability for personal injury or
property damage resulting from the misuse of the H2O MOP X5™, including the
failure to comply with the instructions contained in this User Guide or provided by
the manufacturer or distributor of the treated surface.
!
NOTICE
!
IMPORTANT
!
WARNING
!
Make sure that the H2O MOP X5™ is unplugged.
1) Fill the Water Tank with water. Please refer to the “HOW
TO USE THE H2O MOP X5™” section in this manual.
Attach either the round nylon brush or the round copper brush as
explained in the “How to assemble Hand-Held Steamer” section in
this manual.
2) Select one of the following Steam Regulator positions:
1 – Low, 2 – Medium, 3 – High or 4 – Hot Spray.
You can change the Steam Regulator position and
the steam output while operating the H2O MOP X5™.
3) Once the unit has been fully assembled and filled with water, plug in
the Power Cord into a grounded electrical outlet.
RED light - Power Indicator will indicate when power is on.
Power Switch ( O / I ) is in the OFF ( O ) position (higher position).
Wait for the Ready-to-Use indicator to turn Green - approximately 20 - 30 seconds.
GREEN light will turn on when the steam mop is ready for use.
When the Ready-to-Use indicator light turns green press the Power Switch ( O / I )
to the ON ( I ) position (lower position).
The Hand-Held Steamer will start
emitting steam.
To stop emitting steam, turn OFF the
unit by pressing the Power Switch ( O / I )
again. If the Power Switch ( O / I ) is
pressed (lower position) prior to the
Ready-to-Use light indicator turning
green, water from previous use will
not be heated and will be forced out
by present steam.
HOW TO USE HAND-HELD STEAMER
ON (I)
Position
(Lower)
OFF (O)
Position
(Higher)
Red - Power ON
Green - Ready to use
CAUTION
… 16 …


Need help? Post your question in this forum.

Forumrules
1

Forum

thane-h2o-mop-x5---kb-6622v

Reset search

  • need to buy a jet nozzle and a brush for my H2O MOP X5 STEAM CLEANER WHERE CAN I FIND THEM Submitted on 13-8-2022 at 01:47

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Thane H2O mop X5 - KB-6622V at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Thane H2O mop X5 - KB-6622V in the language / languages: English as an attachment in your email.

The manual is 1,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Thane H2O mop X5 - KB-6622V

Thane H2O mop X5 - KB-6622V User Manual - Dutch - 19 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info