562449
7
Zoom out
Zoom in
Previous page
1/8
Next page
7
• Definion 5 – High End Floor Speakers
Care and cleaning
Ideally, you should remove dust or small amounts of
dirt with a dry, smooth leather cloth.
Rub off stubborn dirt with a damp cloth. Make sure
that no liquid penetrates the speakers.
Then immediately wipe the surfaces dry with a soft
cloth without applying pressure.
Attention
Risk of damage!
Using the wrong cleaning materials may dam-
age the delicate surface of the case.
If possible, only use plain water without any additives.
In case of stubborn marks, a mild soap solution may
be used.
In no circumstances should caustic cleaning products,
white spirit, thinners, petrol or similar be used for
cleaning.
Connecting the cables
1. Turn off your amplifier/AV receiver.
2. Lay the speaker cables from your amplifier/AV receiver
to each of the speakers. Use a high-quality double
wire speaker cable with marked strands for this.
3. A connector terminal with four
terminal clips is located on the
back side of each speaker. You
can connect the speaker cables
directly here or using pin plugs.
The terminals are marked in red (+) and black(-).
Make sure the polarity is correct!
Connect the like coloured terminals. The
speaker connections of your amplifier should
be marked similarly. The strands of the speaker cables
are marked with different colours or shapes.
4. If you use speaker cables with
pin plugs or cable sockets from
our assortment, simply insert
the pin plugs in the upper or
lower connector terminals.
5. The cable sockets are also
mounted on the upper or lower
terminals.
6. If you use speaker wires without
plugs, split the wire down to
approx. 30 mm on both ends
and remove approx. 10 mm
of the insulation on each end.
Twist the wire so that no strands
are protruding.
7. Turn the connector terminal
counterclockwise until loose.
Run the stripped cable end into
the now visible hole. Close the
terminal by turning it counter-
clockwise. The cable has now
been clamped in place.
8. You only have to remove the cable bridges and con-
nect the connector terminals individually for bi-wiring
or bi-amping operation.
To do this, loosen the connector terminals by turning
them counterclockwise and pull the cable bridges out.
The upper terminals lead to the high and medium
range path and the bottom terminals lead to the low
range path.
9. Connect the other end of the speaker cables to your
amplifier/AV receiver. You should be able to find cor-
responding notes in the operating instructions of your
device.
10. Turn your amplifier/AV receiver back on.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Teufel Definion 5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Teufel Definion 5 in the language / languages: English as an attachment in your email.

The manual is 0,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info