541663
32
Zoom out
Zoom in
Previous page
1/44
Next page
32
Demontage der Anlage
Removal of the system
Démontage du système
Für die Demontage der Außeneinheit benötigen Sie zusätzlich einen Gabelschlüssel SW 13.
Es ist nicht notwendig die Zuleitung zu demontieren.
Gehen Sie wie folgt vor:
l
Lösen Sie die vier Muttern M8, welche die Grundplatte mit der Montageplatte
verbinden. Dann heben Sie die Anlage ab.
l
Lösen Sie die vier Muttern M6 am Abdeckblech unterhalb des kleinen weißen
Steckergehäuses und ziehen Sie das Abdeckblech heraus.
l
Lösen Sie die Steckverbindung des Daten- und des Stromkabels durch Drehen
gegen den Uhrzeigersinn an den Steckern der Zuleitung.
l
Lösen Sie die Steckverbindung des Sat-Kabels durch Drehen gegen den
Uhrzeigersinn an dem Stecker des Koax-Kabels der Zuleitung.
l
Jetzt können Sie die Anlage entfernen.
Um die Anlage wieder zu montieren gehen Sie in der umgekehrten Reihenfolge vor.
The removal of the exterior unit requires a 13-mm open-end spanner.
The supply line does not need to be removed.
Proceed as follows:
l
Undo the four M8 nuts securing the base plate to the mounting plate. Lift off
the system.
l
Remove the four M6 nuts at the cover panel below the small white connector
housing and pull out the cover panel.
l
Disconnect the data and power cables by rotating the supply line connectors
counter-clockwise.
l
Disconnect the satellite cable by rotating the connector counter-clockwise.
l
The system can now be removed.
To reinstall the unit, perform the steps above in reversed order.
Pour démonter l’unité extérieure, vous aurez en plus besoin d’une clé à fourche de 13 mm.
Il n’est pas nécessaire de démonter la ligne d’alimentation.
Procédez comme suit:
l
Desserrez les quatre écrous M8 qui fixent la plaque de base sur la plaque de
fixation puis détachez le système.
l
Desserrez les quatre écrous M6 sur le panneau de protection sous le petit
boîtier de connecteurs blanc et retirez le panneau.
l
Détachez les connecteurs des câbles de données et d’alimentation en tournant
dans le sens contraire des aiguilles d’une montre les connecteurs de la ligne
d’alimentation.
l
Détachez le connecteur du câble satellite en tournant dans le sens contraire
des aiguilles d’une montre le connecteur du câble coaxial de la ligne
d’alimentation.
l
Vous pouvez maintenant retirer le système.
Pour reposer le système, procédez dans l’ordre inverse.
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ten Haaft Oyster Vision at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ten Haaft Oyster Vision in the language / languages: English, German, French as an attachment in your email.

The manual is 4,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ten Haaft Oyster Vision

Ten Haaft Oyster Vision User Manual - English - 8 pages

Ten Haaft Oyster Vision User Manual - German - 30 pages

Ten Haaft Oyster Vision Installation Guide - Dutch - 11 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info