541663
18
Zoom out
Zoom in
Previous page
1/44
Next page
18
Place the external unit on the mounting plate with the connector housing and the cable outlet of the external unit
facing towards the rear of the vehicle. An installation in any other position is not permitted and will cause the warranty
to be invalidated.
When the mounting plate is positioned correctly, the LNB and the connecting cable outlet must point towards the rear of
the vehicle.
Attaching the threaded elbow fitting (cable feed-through)
The threaded elbow fitting on the roof must be located with the cable inlet pointing to the rear of the vehicle,
thus protecting it against splash water.
To make the routing of the cables inside the vehicle easier, the distance between the elbow fitting and the control panel
and the receiver should be as short as possible.
a) Fabricate a hole of 20 to 30 mm diameter in the roof for the cable feed-through.
b) Route the cable tidily on the roof of the vehicle (e.g. using a cable duct) and
guide the cable coming out of the threaded elbow fitting downwards to the
control panel.
c) The small mounting plate of the threaded elbow fitting is bonded to the roof
of the vehicle using commercially available body sealing compound and is
then secured to the roof with screws. Please use a special cleaning agent to
clean the mounting plate and roof as recommended by the manufacturer of a
highly adhesive body sealing compound (e.g. Sikaflex, Teroson 1K-Pur, Würth
Klebt und Dichtet). Once the cleaner has dried off, apply the sealing
compound to the underside of the mounting plate. After fitting the mounting
plate, secure it to the roof using the 4 supplied self-tapping screws.
Elbow connector
ø
20-30 mm
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ten Haaft Oyster Vision at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ten Haaft Oyster Vision in the language / languages: English, German, French as an attachment in your email.

The manual is 4,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ten Haaft Oyster Vision

Ten Haaft Oyster Vision User Manual - English - 8 pages

Ten Haaft Oyster Vision User Manual - German - 30 pages

Ten Haaft Oyster Vision Installation Guide - Dutch - 11 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info