629389
20
Zoom out
Zoom in
Previous page
1/28
Next page
AUX relay – switched terminal for TV set
20
The Vision III control unit provides a switched terminal that can be used to switch
the TV set‘s power supply on and off.
This switched terminal is always closed when the Vision system is in operation and
opens when the system is switched off (standby or sleep).
The TV set is then always disconnected from the on-board electric system when the
Vision system is not in operation, thereby saving standby power.
Caution:
l The switched terminal does not represent a power supply! The TV set must be
supplied with power via a separated cable. Never branch the power for the
TV set off the Vision system‘s power supply! (Be sure to observe the
installation instructions!)
l Some TV sets are fitted with an integrated satellite receiver. If such a receiver
supplies LNB voltage to control the antenna (see receiver control mode 2 or
mode 3), this device should not be connected to the switched terminal.
Wiring example:
Battery
TV set
Vision III
Control
unit
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ten Haaft Cytrac DX Vision III at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ten Haaft Cytrac DX Vision III in the language / languages: English as an attachment in your email.

The manual is 0,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ten Haaft Cytrac DX Vision III

Ten Haaft Cytrac DX Vision III User Manual - German - 28 pages

Ten Haaft Cytrac DX Vision III User Manual - Dutch - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info