629389

Ten Haaft Cytrac DX Vision III Manual

11
Zoom out
Zoom in
Previous page
1/28
Next page
Automatic search
After switching on the system with button , the antenna opens and moves into
the position in which a satellite was last received.
If no satellite is found, the system starts the automated search for the selected
satellite.
When the search satellite is found, the search function stops and the TV signal is
looped through. A satellite search usually takes approx. 30 seconds, but the search
may take longer depending on the position of the parked vehicle.
If a reference transponder on the satellite fails or if it cannot be received at your
current location, the system will start a teach-in routine that may once take 15 -
25 minutes.
If no TV picture appears after this extended search period, you are most likely loca-
ted in an area in which the selected satellite cannot be received or the signal beam
is obstructed.
In this case, the message „No satellite found“ appears in the display of the control
device.
The automatic search function always assumes that your vehicle is perfectly level. If
this is not the case, then the search period may be extended.
If the antenna is already open, the automatic search function is started as follows:
l Press until the message „Automat. search“ appears in the display.
l Press .
In general, the satellite receiver must not be connected or switched on to perform a
satellite search. However, if no receiver is switched on when the automatic search
ends, a corresponding message is shown in the display to alert you that no image or
sound signals are received.
11
If you wish to select another satellite, please refer to section „Search Satellite“:
Selecting a satellite for automatic search and Satellite swap
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ten Haaft Cytrac DX Vision III at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ten Haaft Cytrac DX Vision III in the language / languages: English as an attachment in your email.

The manual is 0,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ten Haaft Cytrac DX Vision III

Ten Haaft Cytrac DX Vision III User Manual - German - 28 pages

Ten Haaft Cytrac DX Vision III User Manual - Dutch - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info