629389
7
Zoom out
Zoom in
Previous page
1/28
Next page
The first steps
All controls are handled via the control device.
All controls are handled via the control device.
You may choose any location you like to install the control device, but please bear
in mind that it is not waterproof. You may still need to remove the protective film
from the display.
The display of the control device will show the various current operating modes of
the system. We recommend that the control device is positioned in an accessible
location where it is easy to see this information.
The display is illuminated, so it is not a problem if it is installed in a very dark location.
To ensure safe and reliable operation of the system, please make sure the external unit
is in rest mode before disconnecting the control device. Check that no text is dis-
played on the control device – this is an indication that the system is in rest mode.
7
On / Off
We have produced a separate manual – the „Installation Instructions“ – which
covers the installation, wiring and initial taking into operation of your Vision
system.
In its supplied state, a search satellite for the automatic search is already confi-
gured in your Vision system‘s control unit.
A satellite swap is performed by changing the search satellite or via the DiSEqC
signals of the receiver. The signal or DiSEqC ID of the receiver must comply with
the ID list saved in the control unit of your Vision system.
See section: Satellite settings / DiSEqC ID.
Vision
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ten Haaft Cytrac DX Vision III at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ten Haaft Cytrac DX Vision III in the language / languages: English as an attachment in your email.

The manual is 0,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ten Haaft Cytrac DX Vision III

Ten Haaft Cytrac DX Vision III User Manual - German - 28 pages

Ten Haaft Cytrac DX Vision III User Manual - Dutch - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info