541664
22
Zoom out
Zoom in
Previous page
1/30
Next page
21
Neustart der Anlage
Wie bei jedem computergesteuerten Gerät kann es auch bei Ihrer
Visionanlage zu einem „Absturz“ der Software kommen. Ursache hierfür
nnen äußere Einflüsse sein, wie z.B. starke elektromagnetische
Störungen oder auch bisher nicht erkannte Softwarefehler.
Wenn Sie der Meinung sind, dass Ihre Visionanlage falsch reagiert oder
auch überhaupt nicht mehr auf Ihre Bedieneingaben anspricht, so sollten
Sie den Microprozessor neu starten. Dies können Sie aus jedem Zustand
der Anlage auf verschiedene Arten tun.
- Wenn die Sicherung im Kabelsatz für Sie bequem zugänglich ist,
ziehen Sie diese Sicherung und stecken sie nach wenigen Sekunden
wieder in die Fassung.
- Wenn die Sicherung unzugänglich ist, stecken sie auf der rechten
Seite des Bedienteiles den Western-Stecker aus. Dazu müssen Sie
von hinten her den Plastik-Clips gegen den Steckerkörper drücken
und dann den Stecker aus dem Gerät ziehen. Drücken Sie jetzt am
Bedienteil die beiden Tasten und, halten diese fest gedrückt
und stecken den Western-Stecker wieder ein. Jetzt können Sie die
beiden Tasten wieder loslassen.
Bei beiden geschilderten Fällen wird Ihre Visionanlage intern einen
Neustart durchführen. Sollte die Anlage aufgeklappt sein, so wird sie
zunächst einfahren. Nach dem Neustart ist die Anlage im Ruhezustand
und kann dann wie üblich mit der Taste
wieder eingeschaltet
werden.
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ten Haaft Caro Vision at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ten Haaft Caro Vision in the language / languages: German as an attachment in your email.

The manual is 0,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ten Haaft Caro Vision

Ten Haaft Caro Vision User Manual - English - 8 pages

Ten Haaft Caro Vision Installation Guide - English, German, French - 44 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info