649696

Telwin DRIVE 13000 Manual

4
Zoom out
Zoom in
Previous page
1/68
Next page
- 4 -
A-15. ON/OFF switch for the charge level, the output ports (ref.
A-11 and 12) and the LED lights.
A-16. Internal battery charge status indicator LED.
3. INSTALLATION
POSITIONING THE STARTER
When using the starter, position it on a horizontal, at and stable
surface.
4. OPERATING INFORMATION
4.1 How to use the starter:
WARNING: follow these instructions
meticulously,andalwaysintheordergivenbelow!
Alwayspreventtheblackandredclampsfromtouchingeach
other or a common cable!
- Make sure that the vehicle or boat to be started is switched off
(switch or ignition key in the OFF position).
- Connect the red clamp POS. (+) to the battery terminal POS. (+),
then connect the black clamp NEG. (-) to the vehicle chassis or
the battery terminal NEG. (-).
WARNING: failure to follow these rules may
compromisetheoperatinglifeofthedevice:
- Turn thevehicle ignitionto thestart positionforno more
than 3 seconds.
- Ifthevehicleorboatdoesnotstart,waitatleast15seconds
before trying again.
- If the vehicle or boat still does not start, wait at least 2
minutes before trying again.
After a successful start, with the engine running, follow the
sequence of instructions below with great care:
- Disconnect the black clamp (negative) from the vehicle.
- Disconnect the red clamp (positive) from the vehicle.
- Remove the starter cable connector from the starter
- Replace the cables and the starter in their seats inside the case.
It is highly recommended to recharge the starter as soon as
possible.
4.2Usingthestarterasapowerand/orchargingdevice:
- Select the output cable (g. A-4 or g. A-6) with the terminal
suitable for the device to be powered (g. A-7) according to the
required voltage/current;
- Insert the cable terminal into the appropriate output port on the
starter (g. A-10, 11, 12);
- Press the ON button seen in gure A-15
- Insert the other cable terminal into the device to be powered;
4.3 Using the LED lights
- Press and hold the ON button (g. A-15) for a few seconds to
enable the continuous LED light function.
The press the button in the following sequence:
- once to start the blinking light;
- twice to start the emergency signal;
- three times to switch the light OFF.
5.CHARGING
Important!Toachievemaximumbatteryperformance,always
chargebeforeuse,thenaftereverytimeitisusedand,inany
case,atleastevery3months.
The unit can be charged using a 230VAC power supply (using the
power supply adapter supplied, g. A-8) or using a 12V cable with
a jack plug (g. A-5).
Press the button seen in g. A-15 to check whether the battery
needs charging.
The LEDs seen in g. A-16 indicate the charge status of the battery,
which light up as the status increases:
- one LED only: low battery;
- all LEDs are on: fully charged battery.
5.1Chargingwith100Vac-240Vac50/60Hzpowersupply
WARNING: Use the suppliedpowersupply adapter
only!
- Insert the power supply adapter plug (Fig. A-8) into a 230Vac
socket or other compatible with the network voltage.
- Now insert the relative output plug into the charger socket seen
in g. A-9.
- The LEDs seen in g. A-16 light up in sequence when the unit is
charging and remain on when the unit is fully charged.
- The starter is tted with a control device to prevent overcharging
the battery and power unit. Leave the system to charge for as
long as necessary.
5.2Chargingonboardthevehicleusing12Vdcpowersupply:
- Insert the jack plug on the supplied cable (Fig. A-5) into the
cigarette lighter socket in the car or onboard the boat.
- Insert the other terminal of the supplied cable into the starter
charge socket (Fig. A-9).
6.DISPOSINGOFTHEBATTERY
When the starter battery is completely run down it should be sent
to a re-cycling facility. In some countries this is mandatory. Contact
the local special refuse authority for information on recycling.
WARNING:
Do not burn the battery to dispose of it. This could cause an
explosion. Before disposing of the battery, apply insulating tape to
the bare terminals to prevent shorting. Do not expose the battery to
intense heat or re as this could cause an explosion.
SPECIFICATIONS:
DRIVE9000
Type of battery:
- rechargeable factory-sealed lithium-polymer battery.
Battery capacity:
- 9000 mAh
Starter current (12 V):
- 350 A
- (600 A peak)
Starter cables:
- polarised terminals
- copper
- diameter 5.3 mm
2
(10AWG)
- length 250 mm
- PVC insulated
Light:
- LED
Output sockets:
- two USB 5V - 1A/2.1A sockets
- 12 V – 10 A socket
- 19 V – 3.5 A socket
Characteristics:
- ON/OFF switch
- automatic charging level reset switch
- charge level and fully charged indicator LEDs
- continuous, blinking and emergency LEDs
Weight:
- 640 g
Accessories included (g. A):
- Output power unit (g. A-8) 100 V-240 V 50/60 Hz, 12 VDC/1000
mA
- charge cable with 12 V cigarette lighter jack plug
- Input/output connection cables (g. A-4, A-6)
- Various terminals (g. A-7)
DRIVE13000
Type of battery:
- rechargeable factory-sealed lithium-polymer battery.
Battery capacity:
- 12000 mAh
Starter current (12 V):
- 450 A
- (800 A peak)
Starter cables:
- polarised terminals
- copper
- diameter 5.3 mm
2
(10AWG)
- length 250 mm
- PVC insulated
… 4 …


Need help? Post your question in this forum.

Forumrules
1

Forum

telwin-drive-13000

Reset search

  • Quante ore servono per caricare la batteria telwin drive 1330 Submitted on 23-7-2022 at 21:41

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Telwin DRIVE 13000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Telwin DRIVE 13000 in the language / languages: All languages as an attachment in your email.

The manual is 1,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info