725610
1
Zoom out
Zoom in
Previous page
1/2
Next page
Read the instructions carefully
as well as the safety guidelines before use.
1. GENERAL DESCRIPTION
2. SAFETY INSTRUCTIONS
For your safety, this appliance complies with the applicable standards and regulations (Low
Voltage Directive, Electromagnetic Compatibility, Environmental…).
• The appliance’s accessories become very hot during use. Avoid contact with the skin.
Make sure that the supply cord never comes into contact with the hot parts of the
appliance.
• Check that the voltage of your electricity supply matches the voltage of your appliance. Any
error when connecting the appliance can cause irreparable harm, not covered by the guarantee.
• For additional protection, the installation of
a residual current device (RDC) having a rated
residual operating current not exceeding 30 mA
is advisable in the electrical circuit supplying
the bathroom. Ask for installer for advice.
The installation of the appliance and its use must however comply with the standards in force
in your country.
• WARNING: do not use this appliance near
bathtubs, showers, basins or other vessels
containing water.
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety. Children should be supervised to ensure that they do not play with
the appliance.
• When the appliance is used in a bathroom,
unplug it after use since the proximity of water presents
a hazard even when the appliance is switched o.
• This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental capabilities or
lack of experience and knowledge if they have been
given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by
children without supervision.
• If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid
a hazard.
• Stop using your appliance and contact an Authorised Service Centre if:
- your appliance has fallen.
- it does not work correctly.
• The appliance must be unplugged:
- before cleaning and maintenance procedures.
- if it is not working correctly.
- as soon as you have nished using it.
- if you leave the room, even momentarily.
• Do not use if the cord is damaged.
• Do not immerse or put under running water, even for cleaning purposes.
• Do not hold with damp hands.
• Do not hold the appliance by the casing, which is hot, but by the handle.
• Do not unplug by pulling on the cord, rather pull out by the plug.
• Do not use an electrical extension lead.
• Do not clean with abrasive or corrosive products.
• Do not use at temperatures below 0°C and above 35°C.
GUARANTEE
Your appliance is designed for use in the home only. It should not be used for professional purposes. The
guarantee becomes null and void in the case of improper usage.
3. BRINGING INTO SERVICE
1. Lock System (g. 1) : To open the clamps, pull the Lock System back. To lock the clamps: close the clamps and
push the “Lock System“ to the front.
2. Plug in the appliance.
3. Set the ON / OFF switch to position I. (D)
4. Your appliance will heat up very quickly (ready to use in less than 30 seconds) and the temperature will remain
stable throughout use. (g. 2)
5. Select the ideal temperature for your hair using the -/+ buttons (g. 3): press the – button to reduce the
temperature or the + button to increase it. The temperature indicator ashes until the selected temperature
is reached.
6. After use: Place ON/OFF (D) switch in the stop position (0), close the clamps, use the “Lock System”, unplug the
appliance and leave it to cool down completely before putting it away.
Note: To avoid any handling error (inadvertently pressing the +/- buttons during use) this appliance is equipped
with a locking function.
If you wish to lock your temperature setting during use, press the + or – button for 2 seconds. Your setting is
being locked, a padlock appears on the screen.
If you wish to change your appliance’s temperature, you will need to unlock it by again pressing the + or – button
for 2 seconds. Your setting is being unlocked, the padlock disappears from the screen. You can change the
temperature by pressing the buttons +/-.
4. USE
4.1 - How should you straighten your hair?
Hair must be untangled, clean and dry.
Do not use the appliance on synthetic hair (wigs, extensions, etc.).
Form a small lock a few centimetres in width, comb it and place it between the plates. Hold the hair rmly
between the plates and slide the appliance slowly from the roots to the tip of the hair.
The ceramic coating on the plates protects your hair against overheating by uniformly spreading the heat.
• Wait for the smoothed hair to cool down before styling.
HAIRDRESSER’S TIPS
• Always start by smoothing the locks underneath. Work from the back of the neck rst before going onto the
side of the head and nish with the front.
• To avoid streaks along the lengths, work using a smooth and uninterrupted movement.
A – Tongs E – Straightening plates
B Led display: 4 temperature positions +
temperature locking
F
G
– Rotating power cord outlet
– Power supply cord
C -/+ button to reduce/increase temperature H Lock System (to lock and unlock the tongs)
D – ON/OFF switch
www.tefal.com
1800147257
PREMIUM CARE 7/7
EN
KO
5. MAINTENANCE
CAUTION! Always unplug your appliance and allow it to cool before cleaning it.
To clean the appliance, unplug it and then wipe with a damp cloth and dry with a dry cloth.
6. TROUBLESHOOTING
• You’re not happy with the results you’re getting from your straightener:
- Press the straightener plates more rmly against your hair section.
- Slide your straightener more slowly.
- Increase the temperature using the “+” button.
• It’s impossible to change the temperature?
- Check that the temperature level isn’t locked.
• The LED ashes with no indication.
- There is a fault in the appliance. Please take it to an ocially approved service centre
• The plate isn’t static.
- This is quite normal, the straightener is tted with a mobile plate to get better
results from your straightener.
ENVIRONMENT PROTECTION FIRST!
Your appliance contains valuable materials which can be recovered or recycled.
Leave it at a local civic waste collection point.
These instructions are also available on our website www.tefal.com.
E
C
D
F
G
A
B
H
Fig. 2
Fig. 3
Fig. 1
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Tefal HS7460 - Premium Care at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Tefal HS7460 - Premium Care in the language / languages: English as an attachment in your email.

The manual is 0,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info