Once to show transmitter 2
Twice to show transmitter 3
Three times to return to transmitter 1
Note: The transmitter number will only be displayed if there is more than one transmitter detected.
3. To reset the minimum and maximum outdoor temperature data and the times at which they were
recorded, press the OUT key continuously for about 3 seconds. This will reset all minimum and
maximum data recorded to the current time, date and temperature. The min/max temperatures
recorded are of current time and they remain unaffected by the time zone setting.
Note: the MIN/MAX data for each transmitter needs to be reset separately.
TEMPERATURE TRANSMITTER
The outdoor temperature is measured and transmitted every 60 seconds.
The range of the Temperature transmitter may be affected by the temperature. At cold temperatures the
transmitting distance may be decreased. Please bear this in mind when placing the transmitter.
433 MHz RECEPTION:
The Weather station should receive the temperature data within 15 minutes after set-up. If the temperature
data is not being received 15 minutes after setting up (the display shows “---”), then please check the
following points:
1. The distance of the Weather Station or transmitter should be at least 1.5 to 2 meters away from any
interfering sources such as computer monitors or TV sets.
2. Avoid placing the receiver onto or in the immediate proximity of metal window frames.
3. Using other electrical products such as headphones or speakers operating on the same signal
frequency (433MHz) may prevent correct signal transmission and reception.
4. Neighbors using electrical devices operating on the 433 MHz signal frequency can also cause
interference.
41
