735587
3
Zoom out
Zoom in
Previous page
1/8
Next page
3
INSTALLATIE:
1. Het is aan te raden om de CO
2
-sensor in de buurt van de CO
2
-bron aan de wand te
bevestigen, met een minimale afstand van 50cm. Het is beter om de sensor niet rechtstreeks
boven de CO
2
-bron te bevestigen indien deze erg warm wordt (CO
2
-generator). De sensor
moet op een hoogte van +/- 1 meter boven de vloer worden bevestigd. Gebruik hiervoor de
meegeleverde bevestigingsbeugel.
LET OP: zorg dat de Lichtsensor (het melk-kleurige dopje aan de bovenkant van de
CO
2
-sensor) rechtstreeks licht kan waarnemen en niet belemmerd wordt, bijv. door een
plank! Wanneer u de lichtsensor/CO
2
-sensor onder een plank bevestigt kan deze niet
waarnemen of het dag of nacht is!
1. Monteer ook de TechGrow T-1 controller aan de wand met de meegeleverde
bevestigingsbeugel.
2. Sluit de sensor aan op de TechGrow T-1 controller met de bijgeleverde UTP-kabel.
3. Stop de stekker van de CO- bron in het stopcontact van de TechGrow T-1 controller.
4. Stop de stekker van de TechGrow T-1 controller in een 230V stopcontact.
5. Klaar!
RESET GEHEUGEN MIN/MAX CO
2
-WAARDEN
Indien er geen pijltje (=>) of knipperend blokje (*) in het display staat: houd de DDK
4 seconden ingedrukt. De min/max waarden worden vervangen door de huidige
CO
2
-waarde.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for TechGrow T-1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of TechGrow T-1 in the language / languages: Dutch as an attachment in your email.

The manual is 0,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info