487973

Teac R-5 Manual

4
Zoom out
Zoom in
Previous page
1/124
Next page
44
Before Use
< As the unit may become warm during
operation, always leave sufficient space
around the unit for ventilation.
< The voltage supplied to the unit should
match the voltage as printed on the label
of the AC adaptor. If you are in any doubt
regarding this matter, consult an electrician.
< Choose the installation location of your unit
carefully. Avoid placing it in direct sunlight or
close to a source of heat. Also avoid locations
subject to vibrations and excessive dust, heat,
cold or moisture.
< Do not place the unit on an amplifier/
receiver.
< Do not open the cabinet as this might result
in damage to the circuitry or electrical shock.
If a foreign object should get into the unit,
contact your dealer or service company.
< When removing the power plug from the
wall outlet, always pull directly on the plug,
never yank the cord.
< Keep this manual in a safe place for future
reference.
Maintenance
If the surface of the unit gets dirty, wipe with a
soft cloth or use a diluted mild liquid soap. Be
sure to remove any excess liquid completely.
Do not use thinner, benzine or alcohol as they
may damage the surface of the unit. Allow the
surface of the unit to dry completely before
using.
Rechargeable Batteries
The R-5 uses a Nickel-Metal-Hydride battery pack
stored in the battery compartment. Leaving the
AC adaptor connected to the R-5 and plugged
into an AC line, ensures the batteries will be
fully charged when you need to use the R-5
on battery power. The R-5 can be used for 5
hours after batteries are fully charged. (When
the volume is set to 20.)
< When the R-5 is not being used but the AC
adaptor is plugged in, the batteries will be
completely charged within approximately 3.5
hours from a full discharge.
< When the R-5 is ON and the AC adaptor
plugged in, the batteries will be completely
charged within approximately 24 hours.
< It may take up to 4 charge and discharge
cycles before the batteries are operating
at full capacity when the R-5 is new or left
unused for several weeks.
It is suggested that the R-5 be plugged in for
about 12 hours before you use it for the first
time.
< Once the R-5 has been fully charged while it
is STANDBY, do not unplug the AC adaptor
and then immediately plug it again. This
will restart the charging cycle even though
the batteries are fully charged. Doing this
repeatedly will damage the batteries.
< If the R-5 is not plugged in, the batteries will
slowly discharge as a safety measure.
< The cycles of recharging the Nickel-Metal-
Hydride battery pack diminish the battery’s
capacity. It is called “Memory effect”. To
prevent this, sometimes the battery must be
fully discharged before you recharge it.
To discharge the battery, unplug the AC
adaptor and leave the R-5 ON until it will
shut off automatically. If you feel the battery
capacity was reduced, leave the battery
unused for several weeks.
… 4 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Teac R-5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Teac R-5 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info