727626
25
Zoom out
Zoom in
Previous page
1/28
Next page
English
water received plate, or drain out the water by
leaning the unit, then shift the unit mode to Fan
mode, and press the button till it low fan speed.
-Keep this mode for half day till the conduit is
dried. Doing like this can keep the inner unit dried
and not go mouldy.
- Turn off the unit and pull out the plug.
- Coil the wire and bind it together, then put it into
the accessories room.
- Separate the air-exhausted pipe and safely
keep it.
- Put the unit into a plastic bag, and then keep it
in a dried place.
- Take out the batteries of remote control and
safely keep them.
Anomalies and repair
- Take the appliance to an authorised technical
support service if product is damaged or other
problems arise. Do not attempt to disassemble or
repair the appliance yourself as this may be dan-
gerous.
- If any anomaly is detected, check the following
table:
Anomalies Causes Solutions
The unit does not
work
- No power supply
- Water full indicator illuminate
- Screen display “FL”
- Turn on the appliance
- Drain out the inner stored water
- Restart and put back to normal after
power cut and drainage
The unit does not
seem to perform
- Indirect sunlight
- Window or doors open
- Filter is very dirty
- Air inlet or air outlet is blocked
- Room temperature is lower than the
setting one.
- Draw the curtains
- Close windows and turn on another
air conditioner
- Clean or change the air lter
- Clean out the stemming
- Change the temperature setting
The unit noise is too
high
- The unit is not put on a at surface - Put the unit on a at and stable sur-
face that can support its weight
Compressor does
not work
- Heat exceeded protection is active - Re start the unit 3 minutes later till
the temperature low down
Detection codes Meaning
E1 : Coil temperature sensor failure
E2 : Indoor temperature sensor failure
E4 :
Anti-freeze protection: when the coil tempera-
ture is below 0°C, the whole machine will stop.
When the coil temperature rose to 8°C or more,
the protection will leave, and it will restore to its
original work state.
Notice AC 260 KT.indb 25 18/02/2016 19:11
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Taurus AC 260 KT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Taurus AC 260 KT in the language / languages: English, French, Portuguese, Spanish as an attachment in your email.

The manual is 1,91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info