Manual Tanita BC-350 (page 5 of 16) (English, French, Portuguese, Spanish)

545026

Zoom out

Zoom in

1/16

Taking weight measurement only

Select Weight-Only Key

Press the Weight-only key. After 2 or 3 seconds, “0.0” will appear in the display and the unit

will beep. When “0.0” appears in the display, step onto the platform. The body weight value will

appear. If you remain on the platform, the display will flash for about 30 seconds, and then the

power will automatically turn off.

If you step off the platform, the weight will continue to show for about 5 seconds, then

“0.0” will appear and the unit will shut off automatically.

3. Recall Function

The previous readings of the following features can be obtained using the recall function.

Weight

Body Fat %

Total Body Water %

Muscle Mass and Physique Rating

BMR and Metabolic Age

Bone mass

Visceral Fat Level

To obtain previous readings, press the RECALL button while the current readings are being displayed.

To see other previous readings, press the appropriate feature button for each desired reading.

Press the RECALL button again to go back to the current readings.

Note : For children (age 7-17), the unit will only display the Weight and the Body Fat % (it will not display the Healthy

Range Indicator).

Guest mode allows you to programe the unit for a one-time use without resetting a

Personal data number.

Press Guest button to activate the unit. Then follow the steps:

Set Age, Select Female or Male, and Specify Height.

Note : If you step onto the platform before “0.0” appears the display will show “Error”

and you will not obtain a reading.

Programming the guest mode

Troubleshooting

If the following problems occur ...then...

• A wrong weight format appears followed by kg, lb, or st-lb.

Refer to Switching the weight mode on p.3.

• The display shows

and goes off when the personal key pressed.

No data (age gender, height and activity level) has been stored in the memory.

• appears on the display, or all the data appears and immediately disappears.

Batteries are low. When this message appears, be sure to replace the batteries immediately, since weak batteries will affect the

accuracy of your measurements. Change all the batteries at the same time with new batteries.

Note : Your settings will not be erased from the memory when you remove the batteries.

• appears while measuring.

Please stand on the platform keeping movement to a minimum.

The unit cannot accurately measure your weight if it detects movement.

The Body Fat Percentage is more than 75%, readings cannot be obtained from the unit.

• The Body Fat Percentage reading does not appear or

appears after the weight is measured.

Make sure socks or stockings are removed, and the soles of your feet are clean and properly aligned with the guides on the

measuring platform.

• appears while measuring.

Reading cannot be obtained if the weight capacity is exceeded

• No reading is obtained after pressing a feature button.

Step off scale when body fat reading appears, then press feature button.

Specifications

BC-350

Weight Capacity

330lb (150kg) (23st 8lb)

Weight Increments

0.1lb (0.05kg) (0.1lb)

Body Fat Increments

0.1%

Personal Data

4 memories

Power Supply

2pcs.Lithium batteries CR2032 (included)

Power Consumption

60 mA maximum

Measuring Current

50 kHz, 500 µA

Federal Communications Commission and Canadian ICES Notice

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules and Canadian ICES-003. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio communications. However, there

is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of

the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio or television technician for help.

Modifications

The FCC requires the user to be notified that any changes or modifications made to this device

that are not expressly approved by Tanita Corporation may void the user’s authority to operate the

equipment.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Tanita BC-350 in the language / languages: English, French, Portuguese, Spanish as an attachment in your email.

The manual is 3,09 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Tanita BC-350 Manual

Product: