517161
24
Zoom out
Zoom in
Previous page
1/31
Next page
24
§CHECKING AND CHANGING FUSES §
Turn off ignition switch, and check fuses if they are intact. Replace the blown fuse with a new one having
the same specified amperage rating (15A). Using a fuse of more than 15 amperes, a brass or iron wire
to replace a blown fuse is strictly prohibited to avoid damaging the electrical system and the circuit.
Remove the left side cover, and you’ll find the fuse holder near battery.
Open the fuse holder, and pull out the fuse. Check it for damage or broken.
Fuses must be firmly secured with wire connectors when replacing. Loose connections will result
in overhead and damage.
Use only parts having the specified specification to replace electrical components such as light
bulbs. Using parts not having the specified specifications for replacement may cause the fuse to
blow and over-discharge the battery.
Avoid spraying water directly on or around fuse box when washing the motorcycle.
If the new fuse burn out quickly again, please check the faulty reason before replace it again.
Take your motorcycle to your dealer for an inspection if a fuse is blown by unknown causes.
Fuse
CAUTION:
In order to prevent electric leakage and self-discharge when the battery sits idle for long
periods. Remove battery from motorcycle, store it in a well- ventilated and dimly lighted place
after the battery has been fully charged. Disconnect battery’s negative cable if the battery is
still kept on the motorcycle.
If the battery needs to be replaced, replace with a same type battery.
The electrolyte level is incorrect if the motorcycle is not standee on level ground.
Don’t over fill the distilled water other wise the over flay acid fluid will corrode parts.
Keep away from sparks and flames when dealing with the battery.
Don’t clog the breather tube.
The breather tube clogged will break the battery because the inner pressure will be up.
Keep your eyes and skin away from the electrolyte, if touched by the electrolyte, clean with
water immediately or see the doctor.
Notice the polarity of the cables when removing and assembling.
Wire
REMOVE
INSTALLATION
Wire
Fuse joints
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sym WOLF 125 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sym WOLF 125 in the language / languages: English as an attachment in your email.

The manual is 0,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info