586467
39
Zoom out
Zoom in
Previous page
1/46
Next page
9. Pull the rear wheel assembly rear-
ward.
NOTE: Never depress the rear brake
pedal with the rear wheel removed. It
is very difficult to force the pads back
into the caliper assembly.
10.
To replace the wheel reverse the
complete sequence listed.
11.
(Only for Canada) Replace the
cotter pin with a new one.
12.
After installing the wheel, apply the
brake several times and then
check that the wheel rotates freely.
A WARNING
Failure to adjust the drive chain and
failure to torque bolts and nuts
properly could lead to an accident.
Adjust the drive chain as de-
scribed in DRIVE CHAIN AD-
JUSTMENT section after install-
ing the rear wheel.
Torque bolts and nuts to the
proper specifications. If you are
not sure of the proper procedure,
have your
authorized
SUZUKI
dealer or qualified mechanic do
this.
Rear axle nut tightening torque:
100
N-m
(10.0
kgf-m,
72.5
Ib-ft)
A WARNING
Failure to extend brake pads after
installing
the wheel can cause poor
braking performance and may re-
sult in an accident.
Before riding, "pump" the brake re-
peatedly until brake pads are
pressed against the brake disks
and proper lever/pedal stroke and
firm feel are restored. Also check
that the wheel rotates freely.
LIGHT BULB REPLACEMENT
The wattage rating of each bulb is
shown on the table below. When re-
placing a burned out bulb, always use
the exact same wattage rating. Using
other than the specified rating can re-
sult in overloading the electrical sys-
tem or premature failure of a bulb.
A CAUTION
Using a light
bulb
with the wrong
wattage rating can cause electrical
system damage or shorten bulb
life.
Always use the specified light bulb.
Headlight
Position light
Turn signal light
Brake
light/
Taillight
License plate light
12V65W(HB3)
... High beam
12V55W(H7)
... Low beam
12V5W*
12V
21W
12V
21/5W
x 2
12V
5W
* Except for Canada and Australia
HEADLIGHT
To replace the headlight bulb, perform
the following step:
Remove the cover ® by removing the
fasteners
@
(right and left).
High beam
1. Turn the socket © counterclock-
wise and remove it.
2. Disconnect the coupler.
Low beam
1.
Disconnect the socket ® from the
headlight and remove the rubber
cap®.
2. Unhook the bulb holder spring (3)
and pull out the bulb @.
A CAUTION
Oil from your skin may damage the
headlight bulb or shorten its life.
Grasp the new bulb with a clean
cloth.
74
75
vi
39


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Suzuki GSX 1300R 2001 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Suzuki GSX 1300R 2001 in the language / languages: English as an attachment in your email.

The manual is 1,11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info