464692
74
Zoom out
Zoom in
Previous page
1/75
Next page
72
Appendix C
Troubleshooting Tables
Problem Solution
LCD does not show
anything when you touch it.
Batteries may be dead.
Replace the batteries with three new AAA Alkaline batteries.
Check the batteries are properly insert with the + - indications.
Reset the SRC-7000 by press the reset switch. (P.9 o.)
The SRC-7000 doesn’t
operate a device.
Make sure that the desired device on the SRC-7000 LCD panel
has been selected.
Move SRC-7000 closer to the device. The maximum operating
distance is approximately 10 meters (30 feet).
Ensure that you are aiming the SRC-7000 directly at the device
and there are no obstructions between the SRC-7000 and the
device.
Ensure that you have correctly used the learning function to
configure the device or the Pre-Programmed Code has been
properly applied.
Re-teach the malfunctioning key.
The device has already plugged the power.
You cannot operate a
device even after teaching
the device by using the
learning function.
Make sure that your SRC-7000 has correctly learned the target
device’s remote control code.
Delete the device data from the SRC-7000 and carry out the
learning function again.
Make sure you did not program more than one remote for a
given device.
You see an “error” display
on the LCD screen during
the learning procedure.
Make sure you hold the target remote’s key till the screen
displays OK or Error on the screen.
Make sure the two remotes are not too close or too far apart –
keep them about 2~4 inches (5~10 cm) apart, and your device
remote control is aimed directly at the SRC-7000’s learning
eye.
The batteries are sufficient with both SRC-7000 & the target
remote control.
74


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Sunwave SRC-7000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Sunwave SRC-7000 in the language / languages: English as an attachment in your email.

The manual is 2,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info